Germ Guardian H3010 Use & Care Instructions Manual page 4

H3010REV0109 Lead:Digital Humidifier Manual 2L
DIRECTIONS FOR USE IN NORMAL MODE (NO TIMER)
1. Power Button
Before turning on make sure there is water in the unit.
Press the Power Button.
C
Power
2. Cool or Warm Humidification Button
Press to select cool or warm humidification. Water temperature
is maintained at room temperature for cool setting and 80
Sp
degrees for warm.
C
S
Cool/Warm
3. Spray Control Button
When you press the Spray Control Button
Display
there are four options to choose from:
On/Off
Spray
Control
4A. Light Options - Display Button
Press the Display Button to turn the display lights on or off.
Display
On/Off
4B. Light Options - Night Light Feature
Press the Lamp Button at the top of the unit to illuminate
the night light feature.
Lamp
5. Water Refill Button
When the Water Refill Button lights up it is time to refill
the water tank.
E-6
2/24/09 12:55 PM
WARM
Press once for weak
Press twice for middle
Press three times for strong
Press four times for turbo
* You will notice the lights get higher as the spray increases.
Page 4
DIRECTIONS FOR USE IN PROGRAMMABLE MODE
The programmable mode allows you to set the timer to turn the humidifier both on/off at
a daily predetermined time. This mode also allows the clock to be programmed.
Push Power Button On
Select/Set
Program Start
1. Push Select/Set Button until "Start" is blinking on display.
2. While "Start" is blinking, select desired start time using Hour and Minute buttons
(am or pm as indicated).
3. Select Cool/Warm preference.
COOL 4. Select Spray Control preference.
5. "Start" indicator will remain lit once programmed.
Program Stop
1. Push Select/Set Button until "Stop" is blinking on display.
2. While "Stop" is blinking, select desired end time using Hour and Minute Buttons
(am or pm as indicated)
3. "Stop" indicator will remain lit once programmed.
4. To cancel program, press and hold select/set button for two seconds.
Clock Set
1. Clock must be set in order for timer to work properly.
2. Push and hold Select/Set Button until "Time" is blinking on display.
3. Select actual time using Hour and Minute Buttons (am or pm as indicated).
ct/Set
Start
Stop
Time
Hour
H
r
Minute
P
E-7