Advertisement
3D SPY CARD
Unlock secret content with augmented reality technology.
MINIMUM OPERATING SPECS
High Speed Internet Access and USB or built-in Web Camera (640x480 or 320x240)
IE 6, or Firefox 2.0
Windows Vista/XP
1 GB Ram
Pentium 4 Processor
Audio Card for Sound
TO USE YOUR 3D SPY CARDS
1) Click on the 3D Cards tab on the SpyNet™ HQ Website (www.SpyNetHQ.com).
2) On the 3D Cards page, select your card's toy icon from the list.
3) After the page loads, you should see the camera view from your webcam onscreen.
4) Hold your 3D Spy Card up about 6-12 inches (15-30 centimeters) from your
webcam, making sure that the entire face of the card can be seen onscreen.
5) You'll then see a 3D model of your toy appear onscreen. Cover the
your finger to have information windows about the toy pop up onscreen. Cover the
button with your finger to cycle to another 3D toy model.
HOLD 3D SPY CARD APPROXIMATELY ~ 6-12 INCHES/15-30 CENTIMETERS FROM WEBCAM
IMPORTANT SAFETY INFORMATION BATTERY WARNINGS AND PROPER USE
WARNING: Battery acid leakage can cause personal injury and cause damage to the product and surrounding property.
If battery leakage occurs, thoroughly wash any affected skin, making sure to keep battery acid away from eyes, ears, nose
and mouth. Immediately wash any clothing or other surface that comes into contact with leaked battery acid. Leaking
batteries may make "popping" sounds. Dispose according to Local, State and Federal Laws.
TO AVOID BATTERY PROBLEMS:
Do not mix old and new batteries.
Do not use rechargeable batteries.
Never mix alkaline, standard (Carbon-Zinc) and rechargeable (Nickel-Cadmium) batteries.
Only batteries of the same or equivalent type as recommended are to be used.
Batteries are to be inserted with the correct polarity.
Exhausted batteries are to be removed from the toy.
The supply terminals are not to be short-circuited.
Different types of batteries or new and used batteries are not to be mixed.
Non-rechargeable batteries are not to be recharged.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired operation.
Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void
the user's authority to operate the equipment. This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
< Reorient or relocate the receiving antenna.
< Increase the separation between the equipment and receiver.
< Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
< Consult the dealer or an experienced radio / TV technician for help.
PC
MAC
Safari 2.0
Tiger or later (Leopard/Snow
Leopard)
1 GB Ram
button with
PAGE
[
6
]
Advertisement
