Step 12 Completing The Installation - Samsung DW80H99 Series Installation Manual

STEP 12 COMPLETING THE INSTALLATION

1. Open the door and remove all foam, paper packaging, and unnecessary parts.
2.
3. Open the water supply valve to supply water to the dishwasher.
4. Turn on the dishwasher, and then select and run a cycle.
Check if the power turns on correctly and if there is any water leakage while the dishwasher
refer to the user manual or contact a service center 1-800-SAMSUNG (726-7864).
Make sure to check for water leakage on both ends of the water supply line and drain hose
connector.
CAUTION
5. Locate the sound absorber in front of base refer to the fi gure below (ON SOME MODELS).
Check it the black rubber skirt (*applicable models only) should be located inside, and then
sound absorber will be covered it.
6. Confi rm that the kick plate gasket is on the bottom of the kick plate. To install the kick plate,
refer to the fi gure below.
DW80H9950US-00151A-06_EN_150216.indd Sec3:21
the dishwasher, and then go to Step 5 below.
installing the dishwasher _21