Fiat Bravo Owner's Manual page 163

fig. 9
Versions with alloy rims
Proceed as follows:
❒ tighten pin A-fig. 9 in one of the holes
of the wheel hub fastening bolts;
❒ Insert the wheel on the pin and, using
the wrench provided, tighten the bolts
available. This is facilitated by the ex-
tension provided B;
❒ Loosen the pin A and tighten the last
fastening bolt;
❒ Lower the car and remove the jack;
❒ Using the wrench provided, fully tight-
en the bolts in the sequence shown
previously for the space-saver spare
wheel (see fig. 8).
❒ refit the hubcap.
162
When you have finished
❒ Stow the space-saver spare wheel
G-fig. 10 in the space provided in the
boot;
❒ Insert the partially open jack into the
container F and force it slightly into its
seat so that it does not vibrate when
the car is moving;
❒ Put the tools back into their places in
F0Q0217m
the container;
❒ Stow the container complete with tools
on the spare wheel and secure every-
thing with the clamping device E;
❒ Correctly reposition the boot stiff cov-
er.
fig. 10
F0Q0392m