Invicta RT-40 Operator's Manual page 5

Table Saw Mod. RT-40
Saw Guard Adjustment (page 07)
Saw guard/blade slitter adjustment is by handle nº 18. The saw guide/blade slitter support is adjusted by nuts nº19,
and should be readjusted according to the saw blade diameter each time the blade is changed.
Belt Tension Adjustment (page 08)
To adjust belt tension or change belts, loosen screw nº 20 and adjust as necessary. Tighten screws.
Procedure for Changing the Saw Blade (page 08)
Remove the saw guard by loosening the lock handle nº 18. Remove the table blade insert (item nº 21) and depress
the blade locking pin (item nº22). Loosen nut nº 23 with the special wrench supplied with the machine. Change to
the desired blade. Keep all collars clean and free from burrs. Reassemble all components. (Note spindle has LH
thread.)
Table Insert Adjustment (page 07)
The table insert is adjusted at the factory for perfect flush alignment with the top of the table. Should future
adjustment be needed, make adjustments by screws nº 24.
Miter Fence (page 08)
The miter gauge is designed to control the angle of the wood material as it is sawn. The angle is adjusted as
follows: Loosen locking handle nº 25 and turn the guide to the desired angle and retighten the locking handle. The
cutting angle can be read on scale nº 26.
Electrical Protection equipment (page 09)
The machine can be optionally supplied with electrical overload protection. This equipment disconnects the motor
automatically when there is an electrical overload that could damage it. When the motor is disconnected, it is
necessary to reset the therrmal relay by pressing the reset button (point nº 02). Continue by pressing the start
button. On pages 9 thru 12 are electrical diagrams for special motorization.
Machine Identification and Replacement Parts
Every INVICTA machine has a serial number which enables the manufacturer to identify the exact type and date of
its manufacture. At the end of this manual you will find a list of parts which compose your machine with their names
and numbers. Use only genuine INVICTA parts and on your order always mention the serial number, part number
and quantity desired.
4