Setting The Video Mode - PEERTV PeerStation SIG-220 Installation Manual

Setting the Video Mode

5e
5e
Note:
Note:
You must use both connections (analog &
You must use both connections (analog &
digital) to switch between them.
digital) to switch between them.
After choosing the new display mode the
After choosing the new display mode the
screen will go blank, switch your TV set to
screen will go blank, switch your TV set to
the new chosen input and verify the new
the new chosen input and verify the new
display type.
display type.
PeerStation SIG-220 – Installation Guide (Preliminary)
Use the RIGHT arrow key to
select 'TV Standard' and then use
the UP/Down arrows to select the
required parameter. The following
settings are available:
TV Standard: NTSC (US) or PAL
(Mostly Europe). Most current
TVs can play both types
Aspect Ratio: 16:9 (wide-screen)
or 4:3 letterbox (older, standard
TVs). Choose Auto if not sure
Video Port: Choose Composite /
S-Video for Standard Definition
TVs. For true HD performance,
you need to connect either
Component or DVI-to-HDMI
cable, and select Component /
DVI
Video Mode: Choose 480i/576i
for standard TVs, 1080i for
HDTVs
19