Samsung Amor 900X3A User Manual page 78

Using the TPM Security Device
Initializing the TPM chip
When you use the TPM function for the fi rst time or you want to
register the user again, you have to initialize the TPM chip.
• Initializing the TPM chip erases all authentication
information saved on the TPM chip. Any decision to
initialize must be taken carefully.
• To initialize the TPM chip again while the TPM function is
in use, you have to decrypt any existing fi les and folders
encrypted by the TPM function fi rst. Otherwise, you
will not be able to access the fi les and folders after re-
initialization.
1
Restart the computer.
When the Samsung logo screen appears, press the F2 key
repeatedly.
(Optional)
2
If the BIOS screen appears, select the Security > TPM
Confi guration item and press Enter.
SysInfo
Supervisor Password
User Password
HDD Password
Set Supervisor Password
Set User Password
Set HDD Password
Password on Boot
▶ TPM Configuration ▶ TPM Configuration
3
Set the TPM Support item to Enabled and set the Change
TPM Status to Clear.
Phoenix SecureCore Tiano Setup
Advanced Security
Clear
Clear
Clear
[Enter]
[Enter]
[Enter]
[Enabled]
Phoenix SecureCore Tiano Setup
Security
TPM Configuration
TPM Support [Enabled]
Change TPM Status [No Change]
Security Chip State Disabled and Deactivated
No Change No Change
Clear Clear Clear
Enable and Activate Enable and Activate
Disable and Deactivate Disable and Deactivate
Chapter 2.
77
Using the computer
Boot Exit