5.8GHz Parabolic Antenna Manual Rev. A 2006 Antenna Assembly & Mounting The longer the wireless video transmission range is, the more critical the alignment of BOTH the transmitter and receiver antenna. If transmitting over one-mile in range, the vertical or horizontal adjustment of the antennas can be measured in a few degrees.
Page 3
5.8GHz Parabolic Antenna Manual Rev. A 2006 Antenna Assembly & Mounting STEP TWO Mount the “L-Type” bracket to the back of Parabolic antenna as shown STEP THREE DO NOT TIGHTEN BOLTS Mount Two “V-Type” brackets to the mounting pole as shown See Step THREE before tightening bolts for permanent installation.
Page 4
5.8GHz Parabolic Antenna Manual Rev. A 2006 STEP FOUR DO NOT TIGHTEN BOLTS Attach the “L-Type” bracket from parabolic antenna - to the top TWO bolts from the “V-Type” bracket assembly on the pole as shown above. Make Horizontal adjustments to aim the antennna LEFT-RIGHT as required Remove parabolic antenna and permanently tighten four bolts on “V-...
Page 5
5.8GHz Parabolic Antenna Manual Rev. A 2006 STEP FIVE Connect Low Loss Microwave cable between parabolic antenna and video receiver - As shown left & below STEP SIX The elevation of this antenna can be adjusted to maximum 25-DEGREES UP or DOWN as required –...
Page 6
5.8GHz Parabolic Antenna Manual Rev. A 2006 WARRANTY INFORMATION/ TERMS & CONDITIONS VideoComm Technologies, herein referred to as “VCT.” LIMITED WARRANTY VCT hereby warrants, subject to the conditions here in below, that should this product become defective by reason of improper workmanship or material defect during the specified warranty period, VCT will repair the same, effecting all necessary parts without charge for either parts or labor, or replace the unit at VCT option.
Need help?
Do you have a question about the EAT-002 (PARA-5829) and is the answer not in the manual?
Questions and answers