OEM In-Ceiling Subwoofer System C-10SW Installation Manual

PACKAGE CONENTS
MB-C10
Two (2) pairs of steel
mounting rails
ITEM 1 ITEM 2
Eight (8) short screws (Item 1)
and eight (8) longer screws
(Item 2)
OEM Systems Co., Inc.
740 Freeport Boulevard, Suite 106, Sparks, NV 89431 (775) 355-0405
www.oemsystems.com
C-10SW*
Speaker Mounting Handle
Four (4)
Grille
Speaker
Removal
Mounting
Tool
Screws
*Grille also included, but not shown
C-10SW & MB-C10
In-Ceiling Subwoofer System
Installation Guide
The MB-C10 combination mounting & pre-construction bracket and the C-10SW 10" woofer
assembly are packaged and sold separately. These instructions accompany both.
The MB-C10 & C-10SW In-Ceiling Subwoofer system has been designed to
mount directly to 16" OC, 19.2" OC & 24" OC wooden frame construction
members (ceiling joists and trusses).
The integrated system weighs approximately 11 pounds, which is much too
heavy to be suspended overhead in sheetrock especially when you take
into consideration the punishing excursions the 10" long-throw woofer is
capable of.
For the sake of safety, the system is designed such that the entire assembly
is mounted directly to the structure's framing members. It actually re-
enforces the sheetrock by unitizing it, the assembly and the structure's
framing together.
Primarily designed for "new construction", in some cases it may also be
retro-fitted into existing construction, which is to say, after the sheetrock is
in place. This may be accomplished when access to the "other side" may
be gained. The structural mounting bracket may be installed from above
the sheetrock.