Maytag DWC4910AAW Use & Care Manual page 10

Options
Indicator Light
Temp Boost Sensor
The Heating Delay light indicates that the main
wash is being extended to heat the water to
If for any reason the incoming water proper temperature.
temperature is below 120°F, press the On
button to assure the water is heated to proper At the end of the dry phase the Clean light will
temperature for best cleaning and drying remain lit until the dial is advanced to the _.
results. The dial will pause at the -I_ to extend
the main wash and the Heating Delay light will Adding a Forgotten Item
turn on.
For best cleaning, the forgotten item should be
Press the Off button to cancel the Ternp Boost added early in the cycle.
Sensor.
1. Unlatch the door and wait until the sound of
Fan Dry Options circulating water stops.
2. Open the door and add the item.
Press the Heat button to turn the heating
element on during the fan dry period. This 3. Pause before latching the door. The cycle will
option improves drying results, continue at the point it was interrupted.
Press the Air button to turn the heating element
off during the fan dry period. Towel drying may
be necessary.
To Start Dishwasher
After loading set the dial to the desired cycle.
Press button for desired options.
NOTE: Run the water from the hot water tap to
clear the line of cold water before
starting.
Press the door until it latches. The cycle will
begin with a drain prior to fill.
PAGE 9