Advertisement
S E T U P (continued)
Other Controls
Crossover Switch
A)
If you choose to bypass the internal crossover and use an external crossover, such as those located in most
modern receivers and processors, then you will need to fine tune the system based on the adjustments
provided by the manufacturer of your electronics in conjunction with the Level and Phase controls on the
MODEL 500. Note, the Level and Phase adjustments on the MODEL 500 are not bypassed and will still
function as indicated above.
To bypass the internal crossover, move the Crossover switch (6) to the Bypass position. The subwoofer will
now pass signals up to 300Hz.
Auto Power Mode Switch
B)
The same circuit also places the MODEL 500 into standby mode when no signal has been detected for a
period of approximately 10 minutes. This signal sensing circuit can be bypassed by switching the Auto switch
(2) to the OFF position if it is preferable to control the MODEL 500's power with a remotely operated power
source
S P E C I F I C A T I O N S
Frequency Response:
Crossover Frequency:
Phase Adjustment:
Amplifier Output Power:
Distortion:
Audio Inputs:
Input Impedance:
Input Power:
Input Power Connection:
Power (Mains) Fuse:
Power Modes:
Auto Off Delay:
Dimensions:
Weight:
Shipping Dimensions:
Shipping Weight:
MODEL 500 AMPLIFIER
20Hz – 300Hz
40Hz – 120Hz (Low-pass filter with bypass switch)
0 – 180 degrees (Continuously variable)
500 watts RMS into 4 ohms, with thermal and clipping limiters
250 watts RMS into 8 ohms, with thermal and clipping limiters
Less than 0.2% at rated power
Summing stereo line level (RCA x2)
LFE (RCA shared with Left input connector)
Line Level – 20kohms, Unbalanced
120V 60Hz AC
IEC 2-wire receptacle with integral fuse holder
5A 250V GMA style Fast Blow
Auto signal sensing and always on
~10 minutes
16-7/8"W x 3-7/8"H x 14.75"D, (429W x 98H x 375D)mm (with feet, without ears)
15lbs (6.8kg)
21.5"W x 8.5"H x 17.5"D, (550W x 220H x 450D)mm
20lbs (9.1kg)
O W N E R ' S M A N U A L
10
Advertisement
