Advertisement
Quick Links
Other CruzPro Products
l
Depthsounders & Speed/Temperature/Log
l
DC Volts/Amps/Amp-Hour Monitor
l
AC Volts/Amps//Freq/kW Monitor
l
LPG/Petrol Gas Detectors/Alarms
l
Bilge Water Alarms & Bilge Pump Controllers
l
Windlass Controller/Chain Counter
l
Digital Fuel Gauges & Fuel Consumption Calculator
l
Digital Gauges for 1 & 3 Tanks /w Separate Alarms
l
Smart and Manual Alternator Regulators
l
Marine Security System
l
RPM/Engine Hours/Elapsed Time Gauge
l
Digital Oil Pressure Gauge/Alarm
l
Digital Water Temperature Gauge/Alarm
l
One and Three Bank Digital Volts Gauges
l
Digital Amps Gauge
l
Digital Clock/Watch/Race Timers/Alarms
l
8 and 16 Amp Light Dimmers / Motor Speed Controller
l
Solar Panel Charge Controllers 6/8/9 & 20 Amps
l
4 & 8 Channel NMEA Combiners/RS-232 Convertors
l
Engine/Exhaust Temp. Monitor & Digital Pyrometer
l
Remote Digital NMEA 0183 Data Repeater
Notes
Page 14
CruzPro
PR60
Digital Pressure Gauge/Alarm
Introduction
The PR60 Digital Pressure Gauge provides an accurate
display of pressure. Pressure can be displayed up to
6550 units (PSI or Bars) or as a percentage (0 to
100%). The PR60 is pre-programmed for use with all
popular American and European resistive pressure
senders made by VDO, Teleflex, Mercury, GM,
Stewart-Warner, Centroid, Faria and others. Custom
0-5V and 4-20mA versions are also available by special
order. Low and High level alarms can be set over the
entire range of the instrument/sender. When activated,
the built-in 85 dB alarm will sound and the display will
flash. Five levels of backlighting can be selected and all
set-up, alarm values, sender type and maximum tank
capacity are saved in a non-volatile memory. The
PR60 outputs NMEA 0183 serial data or this output pin
can be programmed to activate an external alarm.
Page 3
Advertisement
Summary of Contents for CruzPro PR60
- Page 1 Five levels of backlighting can be selected and all set-up, alarm values, sender type and maximum tank capacity are saved in a non-volatile memory. The PR60 outputs NMEA 0183 serial data or this output pin can be programmed to activate an external alarm. Page 14...
- Page 2 Setting Maximum Tank Capacity ..13 Selecting NMEA 0183 or External Alarm Output Other CruzPro Products ....16 2016 BV Engineering PR60MAN-A http://www.cruzpro.com...
- Page 3 100%). shown in figure 2. If everything is wired correctly you can mount the PR60 in the instrument hole. Be sure the bulkhead gasket is in place and use only finger tension to tighten the bracket hold-down nuts Do not overtighten the bracket or you may damage the case - do not use tools to tighten the nuts.
- Page 4 Selecting Sender Type Mounting and Wiring Press and hold down both the and "+" keys for 10 Drill a 2-1/8" (55mm) mounting hole where you seconds (until you hear a long beep.) Use the desire to mount the instrument (Figure 1). keys to select the correct sender from the list below.
Need help?
Do you have a question about the PR60 and is the answer not in the manual?
Questions and answers