Advertisement
7. Remove the foam shield around the front of the lens and set it aside. (You
will install it on the replacement lens later.)
8. Remove the two (2), black plastic retaining clips on either side of the lens.
Each clip is held in place with two (2), captive Phillips screws. The white,
plastic standoffs serve as "handles" to make removing the clips easier.
9. Carefully remove the lens from the lens cavity by pulling it straight out, then
tilt it upward to allow the vertical lens shift adjuster to clear the opening at
the front of the projector.
020-0960-00 Rev. B
3
Removing the Standard
Lens
Advertisement
