Removal steps of the internal storage drive bracket
1050 Memory module
Removal steps of the memory module
For access, remove these FRUs in order:
•
"1010 Battery pack" on page 66
•
"1020 Bottom door" on page 67
When installing:
• Insert the notched end of the memory module into the memory slot at an angle of about 20 degrees.
Press the memory module firmly, and pivot it downward until it snaps into place. Ensure that the memory
module is firmly installed and does not move easily.
Note: Do not apply any pressure to the memory module.
• If only one memory module is installed, ensure that you install it into the bottom slot, which is the
primary slot.
1060 WWAN card
For access, remove these FRUs in order:
•
"1010 Battery pack" on page 66
•
"1020 Bottom door" on page 67
70
Hardware Maintenance Manual