Acer K135 User Manual page 32

32
Check the information on the splash screen
Take note of the important information on the splash screen. The splash screen
consists of the following items: Projector ID, Acer logo, network information
and instructions.
Projector ID (displayed only when available)
The 4-digit number will not be displayed on the top left of the splash screen
until this option is enabled by the supervisor in the Configure tab under Acer
eDisplay Management. The four digits are given randomly for projector
identification. For more information, please see "Projector ID".
Projector Name (SSID)
The Projector Name and initial Service Set ID (SSID) can be added by the
supervisor on the Configure tab of Acer eDisplay Management. For more
information, please see "Network settings".
Server IP
The Server IP indicates the IP address your projector uses to connect to a wired
or wireless network. It will be 192.168.100.10 for general wireless and wired
connections. The Server IP will be assigned by the wired network with DHCP
enabled. For more information, please see "Network settings".
Security: (None, WPA-PSK, WPA2-PSK)
WPA-PSK (WiFi Protected Access - pre-shared key) and WPA2-PSK are other
individual encryption methods with higher level security. The option is enabled
by the supervisor in the Configure tab under Acer eDisplay Management. For
more information, please see "Security settings".
Follow the instructions on the splash screen to
connect and project
1 Check Projector ID, Projector Name (SSID), Server IP and Security option on
the splash screen. Ask your supervisor to set safer key when Security is
enabled.
Downloaded From projector-manual.com Acer Manuals
NOTE: If a RJ-45 cable is not connected, the LAN IP will be 0.0.0.0.
Note: Make sure the LAN/WiFi setting in the projector OSD is On
when using the WiFi Display and DLNA functions.