Ricatech RMC200 User Manual page 5

5 Adjust the VOLUME ROTARY KNOB to the desired volume level.
6 To pause playback, press the PLAY/PAUSE BUTTON. The PLAY INDICATOR will flash. Press the PLAY
BUTTON again to resume playback.
7 To stop playback, press the STOP BUTTON. The PLAY INDICATOR will go off. .
Skip Forward And Skip Reverse
1 Press the FORWARD SKIP BUTTON or the BACKWARD SKIP BUTTON to select a track.
2 Press the PLAY BUTTON to start playing the selected track
Search Forward And Reverse During Play
PLAYBACK
1 Press and hold the FORWARD SKIP BUTTON or the BACKWARD SKIP BUTTON to search forward or backward
though the selected track.
2 Release the button at the desired point, playback will resume automatically.
Programmed Playback
1 Press the PROGRAM BUTTON. " 01" will shown on the display and the PROGRAM INDICATOR will flash.
2 Press the FORWARD SKIP BUTTON or the BACKWARD SKIP BUTTON to select a track.
3 Press the PROGRAM BUTTON again to store the selected track number.
4 Repeat steps 2 and 3 above to program other tracks.
5 Press the PLAY BUTTON to start Programmed playback. The PROGRAM INDICATOR will be on.
6 To erase the programmed sequence, press the STOP BUTTON twice or until the PROGRAM
INDICATOR is off. Programmed tracks will also erase when the CD DOOR is opened.
NOTE: Maximum of 20 tracks can be programmed to play in any order.
Auxiliary Input
1 You can connect external components to your unit by using the Auxiliary Input.
2 Plug Auxiliary cable into the LINE IN JACK on the back of your unit.
3 Switch the LINE IN SWITCH to the ON position.
4 Plug the other end of the Auxililary cable into the output jack on your desired external component.
5 Check the volume level of your external component.
6 See operators manual for correct operation of the external component.
NOTE: When not using the Auxiliary Input, make sure the LINE IN SWITCH is in the OFF position.
Troubleshooting
There is no Power
1 The AC plugged is not well connected.
2 Check to see that the ON/OFF volume knob is in the on position.
There is no Sound
1 Check the volume level by turning the volume knob.
2 Make sure the LINE IN SWITCH is in the OFF position if the LINE IN JACK is not being used.
Turntable will not work
1 Make sure the function switch is set to phono.
2 Try moving the tone arm to the right until youhear a click.
3 Make sure the protective needle cover isremoved.
CD does not play
1 Check to make sure CD is inserted correctly(label side facing up).
2 Check that the surface of the CD is clean
3 Make sure function switch is set to CD.