Razor RSF650 Owner's Manual page 9

REPAIR AND MAINTENANCE
Replacing Front Wheel
Tools required: Phillips Screwdriver, 14 mm and 17 mm socket wrench.
1
Loosen axle bolt using
a 14 mm and a 17 mm
socket wrench. Slide axle bolt out
and remove front wheel.
Replacing the Chain and Rear Wheel
Tools required: Phillips Screwdriver, 14 mm and 17 mm socket wrench.
1
Loosen the two (2) Phillips
screws and remove chain guard.
4
Install the new chain or wheel
by slipping the chain around the
axle bolt. Slide the axle bolt into
the slots on the frame. Slide
the chain tensioner down and
maneuver the chain onto the rear
sprocket and motor sprocket.
2
Position replacement wheel
in front fork and insert disc brake
into brake caliper.
2
Using a 17 mm and 14 mm
socket wrench, loosen the nut and
axle bolt on the front wheel.
5
Re-attach the chain guard.
3
Slide axle bolt through the
front fork, spacer and wheel hub.
When axle bolt passes through the
other side of the wheel hub, add
the other spacer, and slide through
the front fork. Secure with washer
and nut.
3
Push the chain tensioner down
to loosen the chain and remove
the chain from the wheel sprocket
and motor sprocket. Push wheel
downward to remove.
7
9-4
9-2
9-3
9-3
9-2
Note: the arrangement of the
hardware sequence:
9-4 17mm Nut
9-2 Flat Washer
Front Fork
9-3 Spacer
Wheel
9-3 Spacer
Front Fork
9-2 Flat Washer
9-1 14mm Axle Bolt
WARNING: Failing to
properly adjust and tighten the
nuts and bolts that affix the front
wheel can cause you to lose
control and fall.
16-4
16-3
16-2
16-2 16-3
16-1
Note: the arrangement of the
hardware sequence:
16-4 17mm Nut
16-2 Flat Washer
Frame
16-3 Spacer
Wheel
16-3 Spacer
Frame
16-2 Flat Washer
16-1 14mm Axle Bolt
WARNING: To avoid a
pinch or injury, keep fingers away
from moving sprockets and chain.
9-1