Operation - ATN PS-23 User Manual

fEatuRES
• High Quality light intensifier tube
• Super fast lens system provides the user
with a clear and sharp image
• Built-in Infra Red illuminator lets you see
even in total darkness
• 3x lenses (optional)
• Adjustable Flip-up headmount for hands
free use
• IR-on and Low Battery indicators
• Automatic brightness control for high-light
aPPlIcatIon
The PS-23 Night Vision goggles is one of the most versatile night vision devices available. This unit
can be handheld, head-mounted for hands free usage, it is camera/ camcorder adaptable, and can
be 3x binocular. The intergrated IR illuminator enhances the ability of the user to read maps and oper-
ate in confined, zero light areas. The PS-23 is available with several image intensifier options to meet
a wide array of specification requirements.
The PS-23 night vision goggles is a complex opticoelectronic system for individual use. The device
consists of the objective lens assembly, eyepiece and the body. The body contains an image inten-
sifier tubes assembly with an integrated high voltage power source and the battery housing.
Objective lens protective cover is intended to protect the objective lens from dust and scratches. It
also will act as a daylight filter, allowing you to test the scope in daylight or other bright light situa-
tions. The pinhole in the center of the protective cover allows the user to check the operation ability
of the device in daylight conditions.
NOTE: Do not test the scope in daylight conditions even with the daylight filter/lens cap on for more
than ten (10) minutes.

oPERatIon

• Take the goggles out of the case.
• Install the battery(3 Volt, CR123A) into the housing with the polarity order as shown on the scope.
• Rotate the operation knob from "OFF" position to "ON" position to turn the unit on. The protec-
tive lens cover still attached to the lens. Do not turn the unit on in the daytime without the
protective lens cap on. You should see green glow in the eyepiece.
• Observe the scene and adjust the diopter for optimal image clarity.
• You may now enter a dark environment or simply shut the lights off in order to darken the room.
• Next, remove the lens cap/daylight filter. Adjust the front lens for the distance of the focus. You
should not have to readjust the diopter.
• To turn the unit off, rotate the operation knob from "ON" position to "OFF" position.
focuSIng
To focus the PS-23, first you will
need to adjust the diopter. Simply
turn the diopter clockwise until
it stops. Then, while looking
through the diopter at an object,
slowly turn the diopter back coun-
ter clockwise until the grain in the
image is sharp.
protection , unit will turn off automatically if
exposed to excessive light for more than 10
seconds. If the unit is move away from the
bright light, it will reactivate automatically.
• Rugged and versatile design
• Single switch knob operation
• Camera/camcorder-adaptable
• Uses one 3V lithium battery
• Environmental: Water resistantr
• Lifetime warranty
Operation
knob
2