Troubleshooting - Vitek VT-4060 SR Instruction Manual

ENGLISH

Troubleshooting

Before resorting to maintenance service, please kindly check by yourself with the following chart.
Trouble shooting
Symptom
No power
No picture
Distorted picture
Luminance unsteady
or picture with noise
Unable to play
Key malfunction
Remote control doesn't work
No radio signal
Specification
DVD receiver
Power supply
Power consumption
Working environment
Disc output
Tuner
Power output (Max)
Frequency response instability
The manufacturer reserves the right to make changes to the characteristics of the device without prior notice.
The service life of the device is no less than five years.
Guarantee
Details regarding guarantee conditions can be obtained from the dealer from whom the appliance was purchased. The bill of sale or receipt must be
produced when making any claim under the terms of this guarantee.
This product conforms to the EMC-Requirements as laid down by the Council Directive
89/336/EEC and to the Low Voltage Regulation (23/73 EEC)
A production date of the item is indicated in the serial number on the technical data plate. A serial number is an eleven-unit number, with the first four
figures indicating the production date. For example, serial number 0606ххххххх means that the item was manufactured in June (the sixth month)
2006.
4060.indd 12 4060.indd 12
Cause
The power cord isn't connected
Fuse melting
TV receiver setup is not correct
Video setup is not correct
Video cable isn't connected well
Dirty disc
In fast forward or fast rewind mode
Anti copy circuit influence
Without disc
Disc is damaged
Disc is put upside down
Dirty disc
There are menu on TV screen
Parental control is working
Power wave or other static interference
Remote control is not directed properly
Remote control is too far from DVD unit
Batteries are weak
Antenna is not connected
Signal source is chosen improperly
AC ~230V/50Hz
175W
Temperature
Relative humidity
TV System
Frequency response
S/N(A weight)
THD+NOISE
WOW FLUTTER
AM frequency Range
FM frequency Range
12
Solution
Connect the cord to player
Replace the cord with the same one
Change TV receiver setup
Change video setup
Connect the cable properly
Clean the disc
Sometimes, tiny distortion appears normally
Connect the DVD unit to TV directly
Load the disc
Clean or replace the disc
Load the disc properly
Clean the disc
Use SETUP to turn off menu
Set up parental off or change the setup
Turn on/off the power and try again.
Point the remote control at the sensor
Come inside the remote control operation space
Replace the batteries
Connect antenna
Switch source signal to tuner mode
10°С - +40°С
5% 90%
PAL, NTSC
20 Hz - 20kHz
> 80 dB (1 kHz)
< 60 dB (1 kHz)
Below the limit of apparatus measure
522 kHz – 1620 kHz
64 MHz – 108 MHz
25 W*5 + 50 W
±1.5 dB
23.10.2006 9:25:14 23.10.2006 9:25:14