Note - Panasonic TX-58DX902B Ehelp

Note

TV Guide may also be used to set timer event.
●
Watching > TV Guide > Timer Programming
Timer Programming
●
Timer Programming
●
received via the signal from the broadcaster or service provider.
For recording using
●
Standby.
Depending on the progress of recording, analogue channel may not be
●
selected.
[Only for dual tuner model]
No other channels can be selected while recording of
●
is in progress.
[Only for single tuner model]
Recording an encrypted (copy-protected) programme may not be possible.
●
When the start time comes, the channel may be switched automatically
●
and the video and audio signals may be output. 2 minutes before the start
time, a reminder message may appear if you are watching TV.
dual tuner model]
When the start time comes, the channel will be switched automatically and
●
the video and audio signals will be output. 2 minutes before the start time,
a reminder message appears if you are watching TV.
model]
– To remove the message and start the programming, press OK.
– To cancel the programming, press EXIT.
LED turns to orange in Standby mode when
●
"!" identifies that three or more timer events are overlapped. As for
●
the overlapped recording events, the first event starts and finishes as
programmed. The next event can then start.
"!" identifies that two or more timer events are overlapped. As for the
●
overlapped recording events, the first event starts and finishes as
programmed. The next event can then start.
The recording of
●
channel to the programmed channel a few seconds before the start time.
[Only for dual tuner model]
The recording of
●
to the programmed channel a few seconds before the start time.
single tuner model]
For details of the USB HDD
●
Recording > Technical information
can store up to 15 events.
only works reliably if correct time information is
Timer Programming, the TV must be either on or in
Timer Programming
Timer Programming
- 146 -
Timer Programming
[Only for single tuner
Timer Programming
[Only for dual tuner model]
[Only for single tuner model]
may automatically change the
automatically changes the channel
[Only for
is set.
[Only for