685-8324 immediately to report the damage. If possible please take pictures of the damage. PALLET REMOVAL The Oasis Grab N’ Go cooler is secured to the pallet beneath it. Please follow the instructions below to safely detach the cooler from the pallet 1 Locate the 8 Phillips head screws securing the wood blocks to the pallet.
SaFETY & PrECaUTIONS not left exposed or dangling to prevent accidental injury. DANGER! RISK OF CHILD ENDANGERMENT SAFETY PRECAUTIONS Keep the unit upright during transportation. If the unit is tilted during transportation, please allow the unit to sit PROPER DISPOSAL OF THE REFRIGERATOR upright for a minimum of 2 hours before plugging in the To avoid the possibility of child endangerment, please unit.
MAINTENANCE power cord is too short, have a qualified electrician or service technician install an outlet near the appliance. Use The cooler should be cleaned once a week with power of an extension cord can negatively affect the performance supply disconnected. In cleaning, please use mild rinsing of the unit.
Note: Even though there are no vents at the back of the Oasis, the air intake will come from behind the unit. 3 DO NOT place the cooler in a location with ambient 4 Cooler should not be placed near other equipment that temperatures over 75°F or 50%rH...
ADDING OR REPLACING THE ARTWORK IN THE HEADER OF THE UNIT 1 Power off & unplug Oasis unit 2 Remove top three screws at the back of the unit ▼ 5 Lift the top sheet, remove the artwork and replace it. ▼...
WarraNTY INFOrMaTION ONE YEAR PARTS AND LABOUR WARRANTY: corporation for whom the refrigeration Unit referred to MTL Technologies, Inc. (“MTL Cool”) warrants that every herein is originally purchased. new MTL Cool refrigerated display cooler, the cabinet, NO CLAIMS CAN BE MADE AGAINST THIS and all parts shall not contain any defects in material WARRANTY FOR LOSS OF PRODUCT or workmanship, under normal and proper use and...
Page 11
refrigeration failure. Expenses for travel and transportation for product service in remote locations. WARRANTY IS NOT TRANSFERABLE This warranty is not assignable and applies only in favour The removal and reinstallation of your display cooler if it of the original purchaser / user to whom delivered. is installed in an inaccessible location or is not installed in any unauthorized assignment or transfer shall void all accordance with published installation instructions.
CONTrOLLEr SETTINGS Please verify the make and model of the controller before going forward. MODEL: SF-102 AN ACCESS CODE IS NEEDED TO MODIFY PARAMETERS. PLEASE CONTACT MTL TECH SUPPORT TO RECEIVE YOUR ACCESS CODE 1.888.685.8324 1 Set temperature (compressor stop temperature) 2 Set the parameters adjustment Press SET button, hold for 6 seconds to enter the...
TABLE OF FUNCTIONS ACTIVATED BY THE BUTTONS TECHNICAL SPECIFICATIONS TABLE OF FUNCTIONS ACTIVATED BY THE BUTTONS SETTING THE SETPOINT (DESIRED TEMPERATURE) • Electronic controllers for low temperature ventilated refrigeration units normal operation normal operation button start up • Power supply 115 or 230Vac i t c e f f pressing the button alone...
Need help?
Do you have a question about the OASIS-30 and is the answer not in the manual?
Questions and answers