Inspection And Replacement Of Ez Anker; Long-Term Storage - Oreck SF600 Owner's Manual

Inspection and Replacement of EZ Anker

EZ Anker is a consumable part. Using worn EZ Anker will prevent proper resistance,
and the machine may run rapidly on the ground, which may cause accidents.

Long-term Storage

If you do not plan to use the machine for more than 30 days, please follow these procedures for
proper storage.
If the machine is not stored properly, there is a danger of fuel spoilage, the machine failing to
start, ordifficulty in running the machine.
Please work on the machine in a place that is well ventilated. Gas fumes can fill a room and
cause accidents.
Before working on the machine, switch off the engine and remove the spark plug cord.
Store the machine on a flat surface in a place protected from the elements that is well ventilated
and cool.
When removing fuel, do not work near lit cigarettes or other sources of open flame
Also, keep fireworks and firearms away as there is a danger of the machine catching fire.
When removing fuel, be sure that the engine and muffler have cooled before touching the
machine. There is a danger of burns. Take care to dispose of fuel in accordance with
local laws and regulations.
4. Wash all parts well.
Clean the recoil starter, air filter, muffler, around the carburetor, and inside the belt cover by
blowing air through them to remove dirt and dust.
Remove rust from affected areas and apply anti-corrosion paint.
If you continue to operate with an accumulation of grass and dust in the machine, the engine
can become clogged, causing it to overheat and possibly catch fire.
5. Refuel and lubricate the necessary parts and have any defective parts repaired
6. Put a cover over the machine to keep dust out.
During storage, check the tire pressure periodically and add air as necessary
1. If the length of the EZ Anker has become shorter than
the rotor's rotating radius, it's time for replacement.
When the machine runs rapidly on the ground surface,
please check the EZ Anker for wear.
2. Please attach in the same direction when replacing.
1. Empty fuel from inside the fuel tank and the carburetor.
To remove fuel from inside the carburetor, remove the
drain screw from underneath and allow any fuel to
flow out.
2. Clean away any fuel on the outside of the engine or
machinewith a rag.
3. Please replace the engine oil.
Refer to [ Replacing Engine Oil ]