Sanyo EM-C2001UK Service Manual page 13

NOTES
- When removing the magnetron, make sure that its
dome does not hit any adjacent parts, or it may be
damaged.
- When replacing the magnetron, be sure to install the
magnetron gasket in the correct position and be sure
that the gasket is in good condition.
- After replacing the magnetron, check the microwave
energy leakage to ensure it is below the limit of
5mW/cm 2 .
Duct, front
Exhaust duct
front
Magnetron
front
Exhaust duct
front
Blower Ass'y
front
HOW TO RESET THE MEMORY OF
ACCUMULATIVE COOKING TIME:
Note; Total number of door operation can not be
When new magnetron is replaced, accumulative
cooking time must be set to "Zero" as follows.
(1) Touch "C" key. The "0" appear on the display/
(2) Touch "Clock mark" key. The colon and power
(3) Touch number key "8" three times. The "8.88"
(4) Continuously touch coursse key "1". "88.81" will
Duct,rear
(5) Touch "Start" key. All four digit will be flashing.
(6) Touch "Start" key again. The displayed number
(7) Touch "0" and "Memory" key. Accumulative
Stay
Magnetron
front
Blower Ass'y
rear
Figure 11
- 12 -
cleared.
level ten bar will appear on the display.
will appear on the display.
appear on the display.
shows the accumulative cooking time.
cooking time will be cleared.