Operation - Craig CR41804 Owner's Manual

LOCATION OF CONTROLS:
1
10
3
9
11
12
8
18
16
1. -- AM/FM (POWER On-Off/AM-FM Selection/Alarm Off) Button
2. AL. 1/VOL + (Alarm 1 Set/ Volume Up) Button
3. AL. 2/VOL - (Alarm 2 Set/ Volume Down) Button
4. SNOOZE Button
5. TUN +/HOUR (Tune Up/Hour Set) Button
6. TUN -/MIN (Tune Down/Minute Set) Button
7. TIME/PRESET (Time Set/Memory Preset/Memory Up) Button
8. LED Display
9. PM Indicator
10. SLEEP Button
To set or reset the actual time:
1. Make sure the unit is in radio power off mode before setting.
2. Press and hold the
Press the TUN - /MIN or TUN + /HOUR Buttons to set minute and/or hour.
(Make sure the PM Indicator on the display is light if the time is PM and not light if the time is AM).
3. When finished, press the
blinking.
Radio reception
1. Press the -- AM/FM Button to turn on the radio.
2. The radio frequency will appear on the display. Press the
select AM or FM band as desire.
3. Press and hold the TUN - /MIN or TUN + /HOUR Buttons until the displayed
frequency starts running then release the button to auto searching available radio station.
A. When a radio station is found, the frequency on display will stop running and start playback
automatically.
B. If reception is no good, press the TUN - /MIN or TUN + /HOUR Buttons
repeatedly to fine tune.
2
AM/FM AL.1/VOL+
AL.2/VOL-
SLEEP

OPERATION

TIME/PRESET
Button on the top of unit until the time on display is blinking.
TIME/PRESET
Button to save the setting and exit, the display will stop
- EN 5 -
4
5
TUN+/HOUR DIMMER
TUN-/MIN TIME/PRESET
FM
ANT.
11.
12. Radio (Alarm 1) Indicator
13. Buzzer (Alarm 2) Indicator
14. Radio (Alarm 2) Indicator
15. DC IN Jack
16. Battery Compartment (Bottom of unit)
17. FM Antenna
18. Speaker
19. Sleep Indicator
20. DIMMER Button
-- AM/FM Button repeatedly to
20
7
6
13
14
19
15
17
Buzzer (Alarm 1) Indicator