Advertisement
Washing instruction
Preparation
1. The machine should be placed on level/flat ground. The bottom air vent of
washing machine should be clear from any blockage during operation.
2. This machine uses bipolar plug to assure the safety pipe, gas pipe or heating
pipe.
3. Lay down the over flow hose.
4. Use the water hose to connect the water tap to the water inlet.
5. According to the material and weight of clothes, adjust the level of the water.
6. Switch on the power
7. Before washing, operator must separate white clothes from colored clothes.
Washing
1. Put the clothes and correct amount of detergent into the tub ( excessive
detergent with make it difficult to get rid of the suds and insufficient rinsing may
result)
2. Turn on the water tap to allow water to enter the machine via the water inlet
hose. Adjust the water level according to your requirement.
3. Set the wash selector switch to gentle or normal according to the material and
weight of clothes.
4. Set the wash timer knob to the proper position and start to wash.
5. After washing, set the wash selector switch to the drain off water.
Spin-drying
1. After draining off water, put the clothes to the spin tub
2. Put down safety lid and spin-dry lid.
3. Set the spin-dry timer to the proper time according to the clothes.
Drain washing
1. After washing, the spin tub can be used to drain your clothes.
2. Drain off excess water from clothes and load into the spin tub-
3. Allow clothes to further drain inside the spin tub for 20-30 seconds before
turning on the spin function.
4. Active the spin function to finally remove excess water.
Rinsing
1. Wash tub can also be used rinsing clothes
2. Follow the washing procedure above but not add detergent.
3
Advertisement
