Mounting On A Wall; Separate Purchase (Wall Mounting Bracket) - LG MT57S Owner's Manual

Mounting on a wall

For proper ventilation, allow a clearance of 10 cm on each side and
from the wall. Detailed installation instructions are available from your
dealer, see the optional Tilt Wall Mounting Bracket Installation and
Setup Guide.
10 cm
If you intend to mount the TV to a wall, attach Wall mounting interface
(optional parts) to the back of the TV.
When you install the TV using the wall mounting interface (optional
parts), attach it carefully so it will not drop.
1 If you use screw longer than standard, the TV might be damaged
internally.
2 If you use improper screw, the product might be damaged and
drop from mounted position. In this case, LG Electronics is not
responsible for it.
Separate purchase
(Wall mounting bracket)
Model
Wall mount (A x B)
A
B
Standard screw
Number of screws
Wall mount bracket
(optional)
6
10 cm
10 cm
10 cm
24MT57S
75 x 75
M4 x L10
4
RW120
CAUTION
Disconnect the power first, and then move or install the TV.
y
Otherwise electric shock may occur.
If you install the TV on a ceiling or slanted wall, it may fall and
y
result in severe injury.
Use an authorized LG wall mount and contact the local dealer
y
or qualified personnel.
Do not over tighten the screws as this may cause damage to
y
the TV and void your warranty.
Use the screws and wall mounts that meet the VESA standard.
y
Any damages or injuries by misuse or using an improper
accessory are not covered by the warranty.
Screw length from outer surface of back cover should be under
y
8 mm.
Wall mount Pad
Back Cover
NOTE
Use the screws that are listed on the VESA standard screw
y
specifications.
The wall mount kit includes an installation manual and
y
necessary parts.
The wall mount bracket is optional. You can obtain additional
y
accessories from your local dealer.
The length of screws may differ depending on the wall mount.
y
Be sure to use the proper length.
For more information, refer to the instructions supplied with
y
the wall mount.
Wall mount Pad
Back Cover
Standard screw
: M4 x L10
Max.8 mm