Related Manuals for Shark HV320 Series
Summary of Contents for Shark HV320 Series
- Page 1 OWNER’S GUIDE HV320 series 1- 8 0 0 -7 9 8 -7 3 9 8 w w w . s h a r k n i n j a m a n u a l s . c o m...
- Page 2 ® ™ contained herein are subject to change without notice. This Owner’s Guide is designed to help you get a complete understanding of If you should have a question about your Shark Rocket , please call the Shark ® ™...
-
Page 3: Important Safeguards
READ ALL INSTRUCTIONS BEFORE USE IMPORTANT SAFEGUARDS When using an electrical appliance, basic safety precautions should GENERAL USE always be observed, including the following: 17 Use only as described in this manual. WARNING 18 DO NOT put any objects into openings. DO NOT use with any opening blocked; keep free of dust, lint, hair, and anything that may reduce air flow. - Page 4 ASSEMBLY Insert the tube into the floor nozzle connector. Insert the handheld portion into the top of the tube. This vacuum comes with a detachable clip to store up to two accessories on board. Snap the detachable clip onto the tube. Store one accessory on top holder and one accessory on bottom holder.
- Page 5 FLOOR This vacuum has a 2-speed POWER slider switch, optimized for bare floor, delicate area rug and carpet cleaning. CLEANING The floor nozzle is equipped with headlights that illuminate the floor surface being cleaned. The lights turn on in either speed setting. Plug the unit into an outlet.
- Page 6 ABOVE FLOOR This vacuum has the reach to clean up above floors or in tight spaces by using the tube. It also has the convenience of a handheld vacuum when using it without the tube and a light to illuminate the cleaning surface. CLEANING Stand the vacuum upright.
- Page 7 STORAGE There are two recommended ways to store this vacuum. OPTION 1: Press the button on the top of the tube and pull to separate it from the handheld portion of the vacuum. There is a hook on the bottom of the handheld portion.
- Page 8 Crevice Tools Dusting Brush On-Board Wide Upholstery Tool Upholstery Tool a. 12.7 cm crevice tool - 226FFJV300 a. 229FFJV300 c. 165FLIHV3 b. 28 cm crevice tool - 163FLIHV3 b. 166FLIHV3 ACCESSORIES Cleans hard surfaces and Remove pet hair and c. 30.5 cm crevice tool - 227FFJV300 upholstery.
- Page 9 Multi-Tool Wall Mount 230FFJV300 240FFJV300 3-in-1 wide mouth combo tool cleans hard surfaces and upholstery Home & Car Detail Kit Appliance Wand XCDV300 138FLIV300 Extension tubes and micro-tools clean tight spaces. Extend to access areas under hard-to-move appliances and furniture. 1- 8 0 0 -7 9 8 -7 3 9 8...
- Page 10 For best results, ensure that the pad is flat against the bottom surface and secured tightly. CLEANING PAD INSTRUCTIONS Use the Dust-Away to clean dry bare floor surfaces. Do not use to clean damp floors or wet / sticky messes. Only use pads provided by Shark , which are designed ™ ®...
- Page 11 HOME AND CAR Press the WAND release button to remove the floor nozzle and wand from the hand vacuum. DETAIL KIT Insert converter onto the hand vacuum. Insert micro-tool adaptor. Attach hose and desired extension tube and cleaning tool. 1- 8 0 0 -7 9 8 -7 3 9 8...
- Page 12 MAINTENANCE EMPTY THE DUST CUP Detach the handheld portion from the rest of the vacuum by pressing the button on the top of the tube to pull it away from the handheld portion. To keep your vacuum’s suction power optimal, follow these Separate the dust cup from the vacuum by squeezing the two “dust cup release”...
- Page 13 MAINTENANCE CHECK FOR BLOCKAGES REMOVE AND INSPECT: Make sure unit is off and cord unplugged. HANDHELD AND TUBE Remove the tube from the handheld portion and check all dust cup intake openings. Remove the floor nozzle from the tube and check the tube for blockages. BOTTOM OF FLOOR NOZZLE Use a coin to unlock the three locks on the bottom of the floor nozzle.
- Page 14 6. Plug in the vacuum. 7. Restart the unit by turning the power on. Euro-Pro and Shark are registered trademarks of Euro-Pro Operating LLC. Rocket, Dust-Away and TruePet are trademarks of Euro-Pro Operating LLC. w w w . s h a r k n i n j a m a n u a l s . c o m...
- Page 15 call 1-800-798-7398 or visit our website www.sharkninjamanuals.com. call 1-800-798-7398 or visit our website www.sharkninjamanuals.com. 1- 8 0 0 -7 9 8 -7 3 9 8...
- Page 16 EURO-PRO Operating LLC 180 Wells Avenue Suite 200, Newton MA 02459 United States of America 1-800-798-7398 www.sharkninjamanuals.com HV320�INTL�40�IB�150707�2 Printed in China © 2015 Euro-Pro Operating LLC Illustrations may differ from actual product. 1- 8 0 0 -7 9 8 -7 3 9 8 w w w .