Advertisement
Always choose a safe location for the fan, keeping in mind the safety precautions
outlined. Ensure all packaging has been removed from the unit before use. This
appliance requires no installation, it should be used solely as a portable
appliance.
Assembly
Pass the cord through the base. Assemble the two
base halves together. Position the base half with the
alignment pin, over the other base half with the
alignment sockets. Press the two halves together until
flush.
Assemble the base to the main body.
With the tower on its side, align the base sockets onto
the main body pins. Tighten the screws securely but do
not over tighten.
WARNING Keep all objects at least 1 metre from the
front, sides and rear of the appliance
IMPORTANT! NEVER COVER THIS APPLIANCE!
Place the tower on a dry, level and sturdy surface.
Plug the power cord into the socket.
Power
The fan functions ON and OFF by pressing the
ON/OFF button. The corresponding light will illuminate
on the control panel to indicate power.
PROOF OF PURCHASE
To receive warranty retain receipt as proof of purchase. (Refer to back of booklet).
Operating your Fan
SUPPORT AND TECHNICAL ADVICE
Goldair – New Zealand
Monday – Friday 8am-5pm
Phone +64 (0)9 917 4000
Phone 0800 232 633
info@cdb.co.nz
Fan Speed
The fan speed can be adjusted by pressing the SPEED
button.
Each press of the speed button will change the fan
speed between High-Mid-Low. The corresponding fan
speed light will illuminate on the control panel.
Timer
The fan has an automatic timer to turn the unit OFF at
intervals of 1 to 7 hours. To set the timer, turn the unit
on at the required speed, press the TIMER button until
the desired run time is illuminated.
The fan will turn off once the time has expired.
Oscillation
The oscillation feature can be activated by pressing the
OSC button. The fan can be set to a stationary position
by pressing the button again.
Remote control
The functions on the remote control are the same as on
the control panel, except for the speed selector.
The ON/OFF button on the remote control will also
adjust the speed.
Press the ON/OFF button to start the fan. The default
speed setting is low. Press the ON/OFF button again to
change the speed to medium, and again to change the
speed to high. Pressing the ON/OFF button for a fourth
time will switch the unit off.
Cleaning and Maintenance
To avoid risk of electric shock, before cleaning, you
MUST ALWAYS switch off and unplug the fan.
Use only a soft, damp cloth to gently wipe the fan and
dry well.
DO NOT immerse the fan in water and never allow
water to enter the motor housing.
DO NOT use harsh chemicals to clean the fan.
The front grill of your fan is removable for easy
cleaning. The internal unit can be vacuumed to remove
dust and fluff and the fan blade can be wiped down with
a damp cloth.
Goldair – Australia
Monday – Friday 8am-5pm
Phone +61 (0)3 9365 5100
Phone 1300 465 324
info@cdbgoldair.com.au
Advertisement
