Fitting The Camera; Tools Required - Waeco PerfectView CAM604 Installation And Operating Manual

Fitting the camera

8 Fitting the camera
8.1

Tools required

For installation and assembly, you will need the following tools:
 Drill bit set (fig. 1 1, page 3)
 Electric drill (fig. 1 2, page 3)
 Screwdriver (fig. 1 3, page 3)
 Set of ring or open-ended spanners (fig. 1 4, page 3)
 Measuring ruler (fig. 1 5, page 3)
 Hammer (fig. 1 6, page 3)
 Centre punch (fig. 1 7, page 3)
To establish and test the electrical connection, the following tools are
required:
 Diode test lamp (fig. 1 8, page 3) or voltmeter (fig. 1 9, page 3)
 Crimping tool (fig. 1 10, page 3)
 Insulating tape (fig. 1 11, page 3)
 Cable bushing sleeves (optional)
To fasten the cables you may require additional cable binders.
8.2 Fitting the camera
!
CAUTION!
Select a location for the camera and attach it firmly enough so that
it cannot under any circumstances fall off and injure bystanders
(e.g. by being knocked off by branches brushing over the roof of
the vehicle).
I
NOTE
If installing the camera alters the vehicle height or the length spec-
ified in the vehicle documents, your vehicle must be inspected by
the appropriate authorities.
This authority must note any such changes your vehicle docu-
ments.
34
PerfectView CAM604
EN