Summary of Contents for CICLOSPORT HAC 4000
- Page 1 HAC 4000 Instruction manual CicloSport · K.W. Hochschorner GmbH Konrad-Zuse-Bogen 8 · D-82152 Krailling Internet: www.ciclosport.de · e-mail: ciclosport@ciclosport.de...
-
Page 2: Table Of Contents
Content: Battery (1x) Typ 23 A Battery (3x) CR2032 HAC 4000 Spoke magnet Watch with Handlebar bracket O rings wristband with integrated receiver Transmitter belt Speed transmitter Cable ties Breast belt (adjustable) table of Contents 1. General Information ......3 CA oFF/on –... -
Page 3: General Information
1. General InformatIon 2.3 Attaching the handlebar bracket and speed transmitter is a multi-functional device which unifies a heart rate monitor, an altimeter, and a wireless cycling computer in one. The handlebar mounting can be installed on a stem. To do this the That is why it is the ideal device for monitoring training. -
Page 4: Basic Settings
4. basIC settInGs 2.5 Attaching the HAC to the handlebar bracket has two setting modes (these will be called mode 1 and mode 2 in the following instructions). To switch to setting (the must be attached to the handlebar bracket in mode 1, press the UR-button for 4 seconds. To switch to setting order to be used as a bike computer) mode 2, press the LR-button for 4 seconds. -
Page 5: Measurement Of The Wheel Circumference (U)
W – body weight The wheel circumference can be taken from the following table or Set with UL- or LL-button measured by yourself. Standard value = 70 kg tire size Circumference tire size Circumference Setting range min. = 30 kg / 66 lbs, 40-559 26 x 1,5 2026 mm... -
Page 6: Hl 2 – Heart Rate Upper Limit 2
Setting range = 0 - 99.59 minutes . If there is a newer firmware available for your (see www.ciclosport. de), you can start the firmware upload at this point with short 1. Countdown 1 / Countdown 2 is a stop-watch which runs simultaneous pressing both left buttons (UL- and LL-button), that backwards (see chap. -
Page 7: Cd Off/On – Heart Rate Time Manager On/Off
HL – heart rate limit 1 / 2 – adjust total kilometres/ Select with UL- or LL-button reset total values Here you can choose, if the current training Set with UL- or LL-button should be within the heart rate limit 1 or the Setting range: 0 –... -
Page 8: Upper Display Indications
Maximum heart rate The following applies for all sub-functions: Sub-function of function ‚Current heart rate‘ Sub-functions are displayed for 10 seconds, then the main function Indicates the maximum heart rate. appears again. To premature quit the sub-function, press short the UL- or LL-button. -
Page 9: Current Gain Or Loss In Altitude
Average gain in altitude Maximum temperature Sub-function of the function ‚Current gain or Sub-function of the function ‚Temperature‘. loss in altitude‘. Indicates the highest temperature measured Indicates the average gain in altitude since the during the tour. beginning of the tour. Range: -20 to +60 °C resp. -
Page 10: Countdown
Countdown Daily ride time To start the countdown (resp. the (only in bike mode) heart rate time manager) press Indicates the time travelled (without stopping- start/stop-button short. times, i.e. the time is only calculated when the After starting the wheel turns). counts back the indicated time to The measurement starts with the first and ends zero. -
Page 11: Maximum Altitude
Heart rate automatic Range: 0 – 999999 kcal (the 6. position is If the HAC 4000 does not receive a signal from the transmitter belt shown on the decimal point of the upper within 5 minutes (e.g. transmitter belt or receiver are out of range ),... -
Page 12: Clock Alarm
2. When this time has been rea- ched, a signal tones 20 sec. (to premature turn Important: For the HAC 4000 to calculate and indicate all off the signal press any button). values (and store them for the pc evaluation), a recording The clock alarm is switched on/off in set- must be started (see below). -
Page 13: Recuperating Heart Rate
6.5 Heart rate limit/time memory By starting the countdown 1 you can train for 30 min. within the heart rate limit 1. After these 30 min. a short signal tones and count- down 2 is starting (with heart rate limit 2). Now you can recuperate The following functions are possible by using the set heart rate limits: within the time of countdown 2 and then train again with countdown - Define two different heart rate limits and choose one of them for... -
Page 14: Battery Change
(+) facing up. Close the battery cap. area, the heart rate will be displayed as usual - distance between HAC 4000 and transmitter Please do not discard used batteries in domestic waste, but belt is too big (max. 60 cm) discard them on your local recycling-point. -
Page 15: Guarantee
D-82152 Krailling Fax: 0049 89 / 859 63 01 E-Mail: ciclo-service@ciclosport.de Please read through the operating manual again carefully before sending in the device (specially chap. 9) and check the batteries. In case of valid guarantee claims, the repaired device or a E-Mail replacement device will be returned free of charge.
Need help?
Do you have a question about the HAC 4000 and is the answer not in the manual?
Questions and answers