Replacing Drive Roll And Wire Inlet Guide; Removing Knob From Front Panel - MAC TOOLS M-25 Owner's Manual

5-3. Replacing Drive Roll And Wire Inlet Guide

2
Tools Needed:

5-4. Removing Knob From Front Panel

3
2
1
4
1 Inlet Wire Guide Securing
Screw
2 Inlet Wire Guide
Loosen screw. Slide tip as close to
drive rolls as possible without
touching. Tighten screw.
3 Drive Roll
Install correct drive roll for wire size
and type.
4 Drive Roll Securing Screw
3
Secure drive roll with screw as
shown.
4
Y Turn Off power.
1 Front Panel
2 Knob
3 Slot
4 Control Shaft
Rotate knob to allow access to slot.
Insert tip of screwdriver into slot,
and while pushing on spring clip,
pull knob off control shaft.
To reinstall, push knob fully onto
control shaft.
1
Ref. 802 285-C
Ref. 803 346 / 802 280-E
OM-219 806 Page 25