RE350K
Quick Start Guide
Hello. Meet your new
Range Extender.
Follow this guide to extend your Wi-Fi network.
Option
1
Setup Using the Mobile App
1 TP-LINK Kasa App
Search for and download the
the App Store or Google play, or simply scan the QR code.
OR
3 Extend your Wi-Fi Network
Launch Kasa and follow the app instructions to extend your Wi-Fi
network.
Sketch
9:41 AM
100%
Sketch
Plug in your Range Extender
Start Configuration Mode
Plug in your Range Extender midway
Press the
between your router and the area
until the 2 bottom lights on the other
with weak Wi-Fi.
Weak
Wi-Fi Area
CONFIG
N E X T
Wireless Adapter
The range extender can also be used as a wireless adapter to connect any
Ethernet-only device, such as a Blu-ray® player, game console, DVR, or Smart TV,
to your Wi-Fi network.
Simply set up the extender using Option 1 or Option 2, and then connect your
Ethernet-only device to the extender using an Ethernet cable.
Technical Support
?
If you encounter any problem during configuration, go to
TP-LINK Kasa
mobile app in
9:41 AM
100%
9:41 PM
APP CONFIG
button and wait
side are blinking green.
My Range Extender
WIRELESS CLIENTS
3
APP
Total Clients
NETWORK DETAILS
2.4
MyHome_EXT
GHz
5
MyHome_5G_EXT
N E X T
GHz
www.tp-link.com
LEDs and Buttons
2 Connect to your Wi-Fi Network
Go to your mobile device's Settings and connect to your
home Wi-Fi network that you wish to extend.
iOS
Carrier
4 21 PM
:
Settings
Wi-Fi
Wi-Fi
MyHome
CHOOSE A NETWORK...
MyHome_5G
Network A
Network
Other...
Label
4 Connect to Extended Networks
Known networks will be joined automatically. If no known
networks are available, you will be asked before joining a
new network.
Unless you customized the extended network names during the
configuration, the extender adds _EXT to the end of the main network's
SSIDs and uses the same Wi-Fi password.
100%
for web support and other troubleshooting information.
Power LED
Blinking: Initializing or updating rmware.
2GHz
5GHz LEDs
and
Blinking: The App-Con g process is initiated.
Green: The extender is connected to the main network.
Amber: The extender is connected but too far away from the router.
Off: No connection.
LED Button:
Press to turn the status LEDs on or off.
Power I/O Switch:
Slide this switch to turn the extender on or off.
Ethernet Port:
To be used as a wireless adapter to connect
Ethernet-enabled device to the wireles network.
Reset Button:
Press for 2 seconds until all LEDs blink once to reset
the extender to factory defaults.
App-Con g:
Press for 2 seconds until both 2.4GHz and 5GHz LEDs
blink green to initiate the App-Con g process.
Android
22%
MyHome
MyHome_EXT
MyHome_5G
MyHome_5G_EXT
7106505854
© 2015 TP-LINK. All rights reserved.
REV 1.0.0