Philips FW545 Manual page 21

Notes:
– Only å å å å å or ∂
during recording.
– During recording, it is not possible to
listen to another source.
Dubbing tapes
tape deck 2)
1 Press TAPE ( TAPE 1•2 ) to select tape
deck 2.
2 Load the prerecorded tape into tape
deck 1 and a blank tape into tape deck
2.
™ Make sure the tape in tape deck 1
3 (For Tape Deck 2 only)
Press SIDE on the remote control to
select the recording side.
4 Press DUB (HSD) once for normal
speed dubbing or twice (within 2
seconds) for high speed dubbing.
™ "NORMAL" (normal speed) or
™ The
• Dubbing will start immediately.
™ The
5 Press Ç to stop dubbing.
Untitled-13
Downloaded From Disc-Player.com Philips Manuals
Notes:
∂ ∂ ∂ mode is available
∂
– At the end of side A, flip the tapes to
side B and repeat the procedure.
– Dubbing of tapes is only possible from
tape deck 1 to tape deck 2.
– To ensure good dubbing, use tapes of
the same length.
(from tape deck 1 to
– During high speed dubbing in Tape
mode, the sound is reduced to a low
volume.
– You can listen to another source while
dubbing.
Recording the mixed sound /
One Touch Recording
has its full spool to the left.
• During microphone mixing, you can
record the mixed sound on a tape in
tape deck 2 except dubbing mode.
• For One Touch Recording, as soon as you
press REC, the current source (CD,
TUNER or AUX) will be recorded on tape
deck 2
"FAST" (high speed) will be
1 Load a blank tape in tape deck 2.
displayed, followed by
2 Press REC to start recording.
"DUBBING".
™ The
REC
flag appears on the display
HSD
3 Press Ç to stop recording.
during high speed dubbing.
Note:
flag starts flashing.
– When you press RECORD while in TAPE
REC
mode, " SELECT SOURCE " will be
displayed. One Touch Recording is not
possible in TAPE mode.
21
Digital Recording via Digital
Out
For CD digital recording, please refer to the
Instructions Manual of the CD Recorder,
digital audio equipment, etc.
flag starts flashing.
RECORDING
3139 116 18533
6/15/00, 1:16 PM
21