Fan And Fan Motor; Defrost Control Assembly; Lamp; Refrigerator Control Box - LG GR-F218 Service Manual

3-3 FAN AND FAN MOTOR

1. Remove the freezer shelf. (If your refrigerator has an
icemaker, remove the icemaker first)
2. Remove the plastic guide for slides on left side by
unscrewing phillips head screws.
3. Remove the grille by removing one screw and pulling
the grille forward.
4. Remove the fan motor assembly by loosening 2 screws
and disassembling the shroud.
5. Pull out the fan and separate the fan motor and bracket.
BRACKET
MOTOR

3-4 DEFROST CONTROL ASSEMBLY

Defrost control assembly consists of defrost sensor and
FUSE–M.
The defrost sensor works to defrost automatically. It is
attached to the metal side of the evaporator and senses its
temperature. At 72°C, it turns the defrost heater off.
FUSE–M is a safety device for preventing over-heating of
the heater when defrosting.
1. Pull out the grille assembly. (Figure 11)
2. Separate the connector with the defrost control
assembly and replace the defrost control assembly after
cutting the tie wrap. (Figure 12)
GRILLE ASSEMBLY
Figure 11

3-5 LAMP

3-5-1 Refrigerator Compartment Lamp
1. Unplug Refrigerator, or disconnect power at the circuit
breaker.
2. If necessary, remove top shelf or shelves.
3. Using a flat instrument, gently pry the cover loose in the
front as shown. Rotate downward to remove rear tabs.
FAN MOTOR
FAN
GRILLE
Figure 10
DEFROST-CONTROL
ASSEMBLY
Figure 12
4. Make sure the bulbs are cool to the touch.
Turn bulbs counterclockwise to remove.
5. Assemble in reverse order by snapping the Lamp Cover
in, engaging the rear tabs followed by the front tabs.
(Max. 60 W-2EA)
3-5-2 Freezer Compartment Lamp
1. Unplug refrigerator power cord form outlet.
2. Using a flat instrument, gently pry the lamp cover loose
in the front as shown. Rotate downward to remove the
rear tabs.
3. Make sure the bulb is cool to the touch. Turn the bulb
counterclockwise to remove.
4. Replace with a new 60-watt appliance bulb.
5. Insert tabs on back of cover into slots in freezer ceiling.
Push cover up to snap front into place.

3-6 REFRIGERATOR CONTROL BOX

1. First, remove all shelves in the refrigerator, than remove
the refrigerator control box by loosening 2 screws.
CONTROL BOX
COVER LAMP
2. Remove the refrigerator control box by pulling it
downward.
3. Disconnect the lead wire on the right position and
separate the lamp sockets.

3-7 MULTI DUCT

1. Remove the upper and lower
caps by using a flat
screwdriver, and remove 2
screws. (Figure 16)
2. Disconnect the lead wire on
the bottom position.
- 7 -
Figure 13
Figure 14
Figure 15
Figure 16