Automatic Code Search (Auto Srch) - Silvercrest SFB 10.1 C3 User Manual And Service Information

SilverCrest SFB 10.1 C3
character of the brand name (e.g. S for SilverCrest), pressing the
button will show the first brand name starting with S. Then you need
to press the
SilverCrest brand.
As well as the digits, the keypad buttons also have characters or symbols
assigned that you can select by pressing them once or more. The
characters or symbols assigned are printed on the number keys.
After selecting a character and waiting for a few seconds, this character
is applied and you can enter the next character. You can enter up to 11
characters for a brand name. If you make a mistake, press
delete the last character and enter it again.
7. Typically, different device manufacturers use different codes for their
remote controls. At this point you'll have to find the optimum code.
The current code is shown under the selected brand name. You can
press the
brand.
8. Now test the code selected by pointing the remote control at the
device and checking if it responds properly to the button pressed . It
is not necessary to exit the setup mode to perform this test.
The following buttons cannot be used for the function test:


the device buttons (4)

the numeric keypad (11)
9. If most of the buttons work properly, press
the device button selected .
10. If no buttons work properly or only a few do, press
next code and repeat the test as described in step 8. Repeat this
procedure as many times as necessary until you have found suitable
code.
Press to go back one menu level. To return to the start window,
press one of the device buttons.
Repeat the above procedure for all devices you wish to control with your
new remote control.

Automatic code search (AUTO SRCH)

1. Press and hold the
2. Press
3. Press the device button for the device you wish to program. Then
press . The remote control starts sending all available codes. This
is indicated by a flashing
By default the remote control sends the code for the
If no code is assigned to the
send for the different devices:

TV:
the remote control sends the code "CH+".
14 - English
buttons to select the preset codes for the desired
,
button for 3 seconds.
, select "CODE SETUP" and then press
and select "AUTO SRCH". Press
buttons to manually scroll to the
, ,
IR icon on the display.
button, the following codes will be
. The code is saved for
to select the
.
button.
to
. Press