Toshiba SD-110EB Service Manual page 68

B
A
Tray
panel (4)
Tray (3)
Fig. 2-1-5
1-1-4. Front Panel and Tray
1. Remove the flexible cable (1).
2. Release four claws and remove the front panel (3).
3. Pull out the tray (2) to this side.
Claw
Tray (2)
Claws
Front panel (3)
Fig. 2-1-6
Note:
• Insert the tray (2) with the front side of the pickup
mechanism assembly descended. (The slider positions
to the left side.)
• The gears are required to match their phases each
other. After setting the gear (3) as shown in the figure
"A", insert the tray (2). When inserting a tray (2), push
the rack gear side shown by the arrow.
Tray (3)
Claws
Tray
panel (4)
Flexible cable (1)
Claw
• Confirm that the mark of the gear matches with the
triangle mark on the reverse side of the tray in the tray
close status. (The gear is rotated with the slider locks.)
(Refer to Fig. B.)
Gear (4)
Gear (4)
Tray rack gear
Marking
Tray (2)
Gear
Fig. 2-1-7
1-1-5. Rear Panel
1. Remove seven screws (1) and remove the rear panel (2).
Fig. 2-1-8
Fig. A
Triangle mark
Position of the line
Pickup mechanism
assembly
Slider
Triangle mark
Fig. B
Screws (1)
Rear panel (2)
Screws (1)