Table of Contents
Advertisement
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Summary of Contents for Logic TRM120
-
Page 1: Operators Manual
TRM120 TRM – ROTARY MOWERS OPERATORS MANUAL WM1-TRM120... -
Page 2: Table Of Contents
Electric start Remote throttle control Throttle park Stopping the engine Transport position Maintenance Maintenance schedule Maintenance history Maintenance procedures 17 - 20 Specifications Parts diagram Parts list 22 - 24 Guarantee Declaration of conformity TRM120 Serial Number: Date of Purchase:... -
Page 3: Introduction
INTRODUCTION With the purchase of your LOGIC TRM - ROTARY MOWER you have made an excellent choice. This machine should give first class service for a long time, if used correctly, and maintained as described in this manual. Fitted with an easy to start engine it has been designed to cope with a wide range of conditions. -
Page 8: In The Interest Of Safety: Do Not
This symbol means WARNING or CAUTION Personal safety or damage will be at risk if these instructions are ignored. Most accidents are caused by neglect or carelessness; Avoid needless accidents by following the safety precautions listed below. IN THE INTEREST OF SAFETY: DO NOT 1. -
Page 9: In The Interest Of Safety: Do
IN THE INTEREST OF SAFETY: DO 1. DO – Follow Engine manufactures guidelines. 2. DO – Ensure all spectators are a safe distance away when operating. 3. DO – Carry out regular servicing and checks before use. 4. DO – Clear cutting area from potential damaging components e.g. stones etc. 5. -
Page 10: Instruction & Warning Decals
INSTRUCTION / WARNING DECALS The above decals should be located on your TRM120. If any of the above decals are not located on your TRM120 or are damaged in any way contact Logic for some replacement decals before use. -
Page 11: Transporting And Lifting
TRANSPORTING & LIFTING Ensure the vehicle used to lift and transport the TRM120 has the necessary lifting and loading capacity. Follow all vehicle manufactures guidelines for lifting. Unladen weights are clearly marked on the Manufactures plate attached to the TRM120 deck. Check the lifting weight... -
Page 12: Attachment To Towing Vehicle
“OK” before moving the vehicle. Use the raise and lower levers to lift the TRM120 clear of the ground. Drive around for a short period of time in a wide open space to ensure you become familiar with the operating width and handling of the machine. - Page 13 QUICK OFFSET DRAWBAR Remove the ‘R’ clip and locking pin; slide the drawbar to the desired position and reposition the locking pin into the securing hole as shown below. There are 4 hole positions as shown below that allow the mower to move to an ‘Off set’ position. Hole position 1 (Zero offset) would mean the mower would follow the towing vehicle straight behind, if the position was then changed to hole 4 this would mean the mower would move by approx 700mm to the right hand side (Based on the below image)
-
Page 14: Starting The Engine
STARTING THE ENGINE READ AND UNDERSTAND THE ENGINE OPERATORS MANUAL BEFORE USE OBSERVE ALL SAFETY PRECAUTIONS; KEEP HANDS AND FEET AWAY FROM THE ROTOR AND OTHER MOVING PARTS. KEEP SPECTATORS AT A SAFE DISTANCE 1. Make sure there is a gap between the blades and the ground / crop 2. -
Page 15: Throttle Park
NB: TRM – Rotary mower is not road legal, and should not be used on public roadways. If you have any specific questions regarding mowing or adjusting the TRM120 to suit your conditions please contact Logic... -
Page 16: Maintenance History
MAINTENANCE All servicing should be carried out by qualified mechanics. Contact your Local dealer for more details. Maintenance Schedule Maintenance Operation: Hourly Daily Weekly Seasonal SEE ENGINE MANUFACTURES MANUAL Engine (See Engine manufacturer’s manual) Remove excess crop gathered on deck Remove excess crop wrapped around rotors Visual check to ensure nothings loose Grease Drive Pulleys... -
Page 17: Engine Maintenance
NB: New drive belts stretch a little after the first few hours of use; so be sure too check belt tension after the first few hours of use. (DO NOT OVER TIGHTEN DRIVE BELTS) Replace any worn or cracked drive belts. Only use Logic specified drive belts as replacements. - Page 18 Figure 8.1 TYRE / PRESSURES WHEEL/TYRE TYPE RECOMMENDED PRESSURE CARLISLE AT 20 x 7 – 8 7 - 10 PSI KINGSTYRE 16 x 6.50 - 8 28 PSI (Max) DO NOT EXCEED RECOMMENDED TYRE PRESSURES 1. Remember that temperature affects pressures: in cold weather the pressure needs to be higher than in hotter temperatures.
-
Page 19: General Inspection
WHEEL BEARING INSPECTION Jack one side of the mower body up, so the wheel is just off the ground. Rotate the wheel by hand, and check the wheel alignment. To check the bearings, try to move the wheel from left to right and feel for any play in the bearings (A), ensure the wheel-locating bolt is tight before you start and follow any jacking procedures. -
Page 20: Specifications
3. Remove the blade bolt (B) 4. Remove the blade, replace or sharpen the blade. 5. Reinstall the blade ensure the blade-securing bolt has a torque setting of 60ft/lbs. 6. Inspect any fasteners before re-assembly, replace if necessary. 7. Reconnect spark plug. FOR REPAIRS BEYOND THE MINOR ADJUSTMENTS LISTED ABOVE CONTACT YOUR LOCAL DEALER SPECIFICATIONS... -
Page 21: Parts Diagram
9: PARTS DIAGRAM... - Page 22 Clamp plate front Centre FSH08025,FWF08,FNN08 S/Screw M8 X 25, Flat Washers, Nyloc Nut WP05,FRP03010 Manufacturers Plate Universal, Rivet Pop 1/8 X 3/8 WS01 Sticker: Logic – 240 X 75 MM WS146 Sticker: Mower Hazard Sticker WS147 Sticker: TRM120 S215-096 Sprocket Spacer Bush 2 MM...
- Page 23 Spacer TRM120-20A Guard Rail FSH08030,FWF08,FNN08 S/Screw M8 X 30, Flat Washers, Nyloc Nut TRM120-37 Spring Tension 5.38 MM Dia TRM120 -25LA Axle L/H TRM120 -25RA Axle R/H TRM120-10 Wheel Arm Locking Pin MSU -S100 Sleeve Flat Grey 31.75 MM X 9.5...
-
Page 24: Guarantee
We accept no liability for normal wear and tear, misuse or abuse, or where recommended maintenance has not been carried out. All guarantee work must be authorised by Logic manufacturing prior to any work being done. Work carried out without our consent may not be reimbursed. -
Page 25: Declaration Of Conformity
LOGIC MANUFACTURING LTD Foundry Industrial Estate Bridge End HEXHAM Northumberland Product Type: TRM120 – ROTARY MOWER RANGE CE – LRM120 Covered By Technical File Number: Serial Number: Standards and Regulations Used: The Supply of Machinery (Safety) Regulations 1992 HSE Guide Lines on ATV Equipment (Agric Sheet No. 11) HSE Guide lines On Agricultural Mowers (Agric Sheet No.25)
Need help?
Do you have a question about the TRM120 and is the answer not in the manual?
Questions and answers