Table of Contents
Advertisement
Connecting AC Power
Product Options
The Bulletin 6156 Industrial Monitor requires a single phase power
supply providing 100 to 250V AC at 50 to 60 Hz. Power must be
available at a grounded three-pin outlet located nearby. Whenever
possible, connect the monitor to the same AC source that supplies
the computer.
To connect AC power to the monitor:
1. Turn off the main switch or breaker.
2. Use the GND point on the rear panel of the monitor to establish a
chassis to earth ground connection. Secure one end of a ground
strap to the GND point. Connect the other end of the ground strap
to a good earth ground.
The ground terminals are M5 screws.
ATTENTION: Chassis ground must be connected
for safe operation of the monitor. The AC receptacle
!
on the monitor is a 3-wire type with chassis ground
pin, and the mating AC cord supplied is a 3-wire
type, designed for connection to a grounded 3-pin
AC outlet. However a properly grounded AC outlet
is not always available, and grounding using a
3-wire cord can easily be defeated. If you fail to
ground the monitor properly, the setup may result in
personal injury from electrical shock or damage to
equipment.
3. Connect the socket end of the AC power cord to the mating
connector on the rear panel of the monitor. Position the power
cord retaining clip attached to the rear panel connector over the
cord's socket to secure it in place.
4. Connect the plug end of the AC power cord to the mains outlet.
5. Restore AC power to the outlet.
The Bulletin 6156 Industrial 14 in. CRT Monitor can be configured
with the following options.
VGA or BNC video cables
keypads
external keyboard connectors
touchscreen
Industrial 14" CRT Monitors
Publication 6156-2.0
9
Advertisement
Table of Contents
