Page 3
OPERATION & MAINTENANCE MANUAL Dear Customer, Thank you for purchasing of the appliance KVS MORAVIA. We trust that our product serves you well. Some important principles should be observed during its operation. Therefore, in your interest, carefully study this manual and operate the product according to the given instructions.
Page 4
Technical Specifications – TYPE 9106 Appliance TYPE 9106 is designed for solid fuel combustion at periodic cycles. The appliance is to be used for typical central heating hot water systems of individual flats, small family houses, weekend houses or cottages, and for cooking or warming food in conformance to the CSN EN 12815:2002 standard, as amended by A1:2005.
Page 5
Description – TYPE 9106 1. Hotplate 2. Combustion chamber gate 3. Thermometer 4. Grate handle 5. Ash receiver gate Figure 1 The upper working surface comprises a hob top. The appliance casing is made of enamelled steel plates. The thermally stressed parts of the appliance are made of cast iron and fired clay.
The controls of the ignition flap are located near the fume outlet port in the back wall of the appli- ance. The flap introduces these operation modes (Fig 2.): Igniation mode – the control lever is retracted (flap open) • Heating (operation) mode – the control lever is extended (flap closed) • TYPE 9106 07/2014...
It can be lowered to cover the hob only when the appliance is not in operation or finishing its operation (no fuel has been added, the appliance is cooling down and the fire in the burner is burning down). TYPE 9106 07/2014...
Provide your warranty certificate, fully completed. A warranty claim may only be raised if all the warranty conditions have been met. After-warranty repairs are performed by the manufacturer or at authorized service centers. TYPE 9106 07/2014...
Important notice 1. Production standards KVS MORAVIA solid fuel appliances are produced in accordance ČSN EN12815:2002 Standard with amended A1:2005, which is valid for the Czech Republic and European Union. 2. Installation and operation standards All the above installation and operation instructions for the appliances primarily comply with the...
Page 11
Department of the Interior Czech Decree No. 111/82 Coll.). Regular operation, especially when using wet fuel, leads to the accumulation of soot and tar in the chim- ney stack. Any negligence of regular chimney inspection and/or sweeping increases the risk of fire inside the chimney. TYPE 9106 07/2014...
Page 12
С Easily flammable sarking felt, cellulose boards, tar panels, wood-pulp fibre, phellem, polyurethane, polystyrene, polypropylene, polyethylene. Warning for places where burns can occur: hob-top • hob frame • combustion chamber door • TYPE 9106 07/2014...
Page 13
Flue gas ducting connection to the Chimney (valid for Czech Republic) properly improperly Figure 3 TYPE 9106 07/2014...
Page 14
The projected design of the heating system should be based on a maximum operation rating • of 5,5 kW. To drain excess heat from the boiler, a radiator may be used. • Dimensional sketech of the Appliance Type 9106 (All of dimensions are in mm) TYPE 9106 07/2014...
Need help?
Do you have a question about the 9106 and is the answer not in the manual?
Questions and answers