Advertisement
Your GamerModz SPS-X3 Controller comes with 5 Programmable Modes - Modes 1 thru 5. To program a Mode,
you must first select the mode (Reference "Toggle Between Rapid Fire Modes" on Page 2).
Once you are in the Mode you wish to Program (Only applies to Modes 1 thru 5) follow the instructions below
to Program that Mode. Your GamerModz SPS-X3 Controller will remember the Re-Programmable Mode settings
even after you turn your controller off.
Programming adjustable Rapid fire modes
Once you are in the Mode you wish to Program, Hold Down the Right Trigger
until the LED begins to flash. Release both the Right Trigger
Hold
Once in Programming Mode you can adjust your shots per second by Tapping Up on D-Pad
Shots per Second and by Tapping Down on the D-Pad
you Tap the D-Pad, your Rate of Fire will Increase or Decrease 1 Shot per Second.
To test the Rapid Fire Rate, fire your weapon by pulling the Right Trigger
Tapping Up
or Down
see graph on Page 4 for Reference.
Once you have the desired Rapid Fire Setting, Tap Right on D-Pad
will flash the number times corresponding to your rate of fire. For Example: 12 Shots per Second, The LED will
flash 12 times.
= Increase Rate of Fire
GamerModz
Adjustable rapid
Fire modes
, then
on the D-Pad until the desired smoothness and rate of fire is achieved. Please
PS4 – SPS-X3 Ver 4.0
and Up on D-Pad
Hold
Until LED
, then
Begins to Flash
to Decrease Shots per Second. Note: Each time
to lock in the rate of fire. The PS4 LED
= Decrease Rate of Fire
, then Hold Up on D-Pad
.
Release
to Increase
. Adjust your Rapid Fire Rate by
= Lock Rate of Fire
4
Advertisement
