INTRODUCTION: 13. Unplug this apparatus during lightning storms or when Congratulations on your Sterling MX Series studio monitor unused for long periods of time. purchase. We are proud to bring our wealth of experience 14. Refer all servicing to qualified service personnel. Servicing is required when the apparatus has been damaged in any and sound innovation to this new product line.
The +2dB setting may be more appropriate. Try the low and high frequency filters to determine which settings are correct for your listening environment and personal preference. MX5 | MX8 POWERED STUDIO MONITOR...
Balanced cables are more resistant to noise than unbal- anced cables. If you have to use unbalanced cables be- cause the source equipment only has unbalanced outputs, be sure to use the shortest possible unbalanced cables. PDIF PHONES LINE OUTPUT LINE INPUT MX5 | MX8 POWERED STUDIO MONITOR...
MX series speakers, connect to control the monitor level independently from the mixer’s main the instrument’s L/MONO and R outputs to the MX speaker inputs. bus level. MONITOR OUT OR C-R OUT OUTPUT OUTPUT MX5 | MX8 POWERED STUDIO MONITOR...
The power cord is plugged into both the IEC socket on the Ideally, the speakers should be located at least 1.5 meters away rear panel of the monitor and into the AC mains. The Sterling from walls or corners. In situations where it is not possible to...
Page 7
• If the monitor is still not responding, it should be returned more susceptible to noise. to the dealer that you purchased it from, or to Sterling, for • All audio equipment should use the same ground point. If servicing.
Line cord: ......UL817 3 pins / 6 ft TWO (2) YEAR LIMITED WARRANTY: Sterling Audio Subject to the limitations set forth below, Sterling Audio® hereby represents and P.O. Box 5111 warrants that the components of this product shall be free from defects in materials...
Need help?
Do you have a question about the MX5 and is the answer not in the manual?
Questions and answers