Additional Information; General Setup Information - Sony slv-688hf Operating Instruction

Additional Information

General setup information

Setting the RF unit
When connecting the VCR to the TV
using only the antenna cable, you must
set the RF UNIT switch on the rear of the
VCR so that the TV can receive the
correct signal from the VCR.
1
Set the RF UNIT switch on the rear of the VCR to CH 3 or CH 4,
whichever channel is not used in your area. If both are used, set the
switch to either channel.
2
Press POWER to turn on the VCR.
3
Press TV/VIDEO on the remote commander to turn on the VIDEO
indicator in the VCR's display window.
4
Press CHANNEL +/– to display a channel number in the display
window. Select an active channel number in your area.
5
Turn on your TV and set it to the channel you selected in step 1
(channel 3 or 4).
The selected TV channel broadcast appears on the TV screen. If the
channels change when you press CHANNEL +/–, you have made the
correct setting.
Whenever you use the VCR, set the TV to the channel selected in step 1.
RF UNIT
CH3 CH4
POWER
Additional Information
TV
CHANNEL +/–
continued
69