Table of Contents
Advertisement
Quick Links
Download this manual
See also:
Operator's Manual
RETURN
EZ-8
Operator's
Manual
Sander
READ THIS BOOK
This book has important information for the use and safe operation of this machine. Failure to read
this book prior to operating or attempting any service or maintenance procedure to your American
Sanders Technology machine could result in injury to you or to other personnel; damage to the machine
or to other property could occur as well. You must have training in the operation of this machine before
using it. If your operator(s) cannot read this manual, have it explained fully before attempting to
operate this machine.
Si Ud. o sus operadores no pueden leer el Inglés, se hagan explicar este manual completamente
antes de tratar el manejo o servicio de esta máquina.
All directions given in this book are as seen from the operator's position at the rear of the machine.
For new books write to: ALTO U.S. Inc., 2100 Highway 265, Springdale, Arkansas 72764.
Form No. 78425B
10/01
AMERICAN SANDERS TECHNOLOGY
Printed in the U.S.A.
Advertisement
Table of Contents
Related Manuals for Alto EZ-8
Summary of Contents for Alto EZ-8
- Page 1 All directions given in this book are as seen from the operator’s position at the rear of the machine. For new books write to: ALTO U.S. Inc., 2100 Highway 265, Springdale, Arkansas 72764. Form No. 78425B...
-
Page 2: Sanding Cuts And Sandpaper
Sanding Cuts and Sandpaper Initial Cut The purpose of the initial cut is to remove old finish and gross imperfections on the floor surface. A coarse abrasive should be used. If the surface is severely damaged by deep scratches, pre-existing dwell marks, uneven planks, etc., it may be necessary to sand across or diagonally to the grain to restore evenness to the surface. - Page 3 EZ-8 Sander Section II Parts and Service Manual (78425B) AMERICAN SANDERS TECHNOLOGY EZ - 8 Sander Operator's Manual Page 13...
- Page 4 AMERICAN SANDERS TECHNOLOGY EZ-8 Sander Assembly Drawing #1 10/01 11 12 19 12 Page 14 AMERICAN SANDERS TECHNOLOGY EZ - 8 Sander Operator's Manual...
- Page 5 AMERICAN SANDERS TECHNOLOGY EZ-8 Sander Assembly Drawing #1 10/01 NOTE: uindicates a change has taken place since last publication of this manual Ref. # Part No. Description Ref. # Part No. Description 41949A Cord, Motor 86114A Screw ½-13 x 2½...
- Page 6 AMERICAN SANDERS TECHNOLOGY EZ-8 Sander Assembly Drawing #2 10/01 39 38 13 14 Page 16 AMERICAN SANDERS TECHNOLOGY EZ - 8 Sander Operator's Manual...
- Page 7 AMERICAN SANDERS TECHNOLOGY EZ-8 Sander Assembly Parts List #2 10/01 Ref. # Part No. Description Ref. # Part No. Description 47387A Switch, Control 69106B Tube, Handle 24525B Housing Control 69107A Tube, Dust 81210A Nut, Fixture 50951A Bag, Dust 980675 Washer...
- Page 8 AMERICAN SANDERS TECHNOLOGY EZ-8 Sander Wiring Diagram 9/92 Page 18 AMERICAN SANDERS TECHNOLOGY EZ - 8 Sander Operator's Manual...
Need help?
Do you have a question about the EZ-8 and is the answer not in the manual?
Questions and answers