Summary of Contents for Prozeda Sunny Scout 1328
- Page 1 Operating manual Sunny Scout 1328 Microcontroller-controlled temperature difference controller for solar thermal systems...
-
Page 2: Table Of Contents
Content Explanation of the graphic symbols Application area / device features 1.1 Application area Attention! 1.2 Device features Symbol indicates Safety instructions possible dangers and errors Mounting the device Attention 230V~ 3.1 Opening the device voltage! 3.2 Wall mounting Symbol indicates 3.3 Connections risks posed by 3.4 Temperature sensor connection... -
Page 3: Application Area / Device Features
◼ Mount the Sunny Scout 1328 controller in a position where it will not be sub�ect- Sunny Scout 1328 controller in a position where it will not be sub�ect- controller in a position where it will not be sub�ect- ed to excessive operating temperatures (>... -
Page 4: Mounting The Device
3.4 Temperature sensor connection The Sunny Scout 1328 devices use PT1000 precision platinum temperature sensors. Mounting / wiring the temperature sensors: ◼ Mount the sensors on the collector and the storage tank. Ensure proper heat transfer and use heat-conducting paste if necessary. -
Page 5: Short Descriptions And Device Operation
Short descriptions and device operation 4.1 Display layout Display symbols During actual operation, these symbols are only displayed for selection once All possible display symbols are depending on the menu position. shown below. ◂ Active menu in the menu levels ◂... -
Page 6: Menu Structure 5.1 "Info" Menu
Menu structure 5.1 "Info" menu The following measured values are displayed automatic in the Info menu: Display Meaning Can be reset e.g. 75 °C Displays current collector temperature 52 °C Displays current storage tank temperature 5.4 "Basic Setup" menu Settings and changes in The hydraulic diagrams and additional functions are displayed in the Basic Setup this menu must only be menu. -
Page 7: System Diagram
System diagram 1 collector, 1 storage tank Switch positions: Temp. diff. controller: all=off 230V connections Heating: 1=on Mains phase Cooling: 1 and 3=on Neutral conductor - mains and outputs Anti-freeze: 2=on RPM-control: 4=on Solar circuit pump (switching output 1) Sensor connections Collector sensor Lower storage tank... -
Page 8: Controller Functions
Controller functions 7.1 General controller functions 7.1.1 Temperature difference The controller compares the temperatures of the various measuring points and op- timally charges the storage tank. If the collector temperature exceeds the storage tank temperature, the solar circuit pump is switched on. Monitoring and protection functions ensure safe operation. -
Page 9: System Monitoring
System monitoring 8.1 Sensor monitoring The connected sensors and sensor cables are monitored for interruptions and short-circuits. Errors are indicated by the symbol. You can find the error source by scrolling up or down the Info menu. 8.2 Flow monitoring The controller is programmed to display a message if the flow is interrupted, e.g. -
Page 10: Faults Without Error Messages
9.2 Faults without error messages Faults that affect the 230V/A mains power Faults and malfunctions that cannot be displayed as well as possible causes and supply must only be remedied by their error source can be identified using the following table. If you cannot remedy a specialist! the fault using the description below, contact the supplier or installer. -
Page 11: Specifications
10 Specifications Housing Subject to change in 100% recyclable ABS housing for wall mount- accordance with technical Material advances! Dimensions W x H x D in mm, 95 x 75 x 50; weight approx. 130 g IP20 according to DIN 40050, IEC 529, VDE Protection class 0470, EN 60529 Electrical specifications... -
Page 12: Warranty Conditions
12 Warranty conditions The Sunny Scout 1328 controllers are carefully produced and tested on an auto- Sunny Scout 1328 controllers are carefully produced and tested on an auto- controllers are carefully produced and tested on an auto- matic testing station. If any failures occur, first check if there are any operation / setting or system errors.
Need help?
Do you have a question about the Sunny Scout 1328 and is the answer not in the manual?
Questions and answers