Bosch JSH180 Operating/Safety Instructions Manual page 9

BM 2610027775 09-12_BM 2610027775 09-12.qxp 9/10/12 6:55 AM Page 9
BLADE INSTALLATION AND REMOVAL
This jigsaw is equipped with the Bosch "One
Touch" tool-less blade changing system. This
system makes changing blades simple and
fast.
Insert the saw blade (teeth in cutting
direction) until it latches in the plunger
(Fig. 2.) When inserting the saw blade, the
back of the blade must rest in the groove of
BLADE
ATTACHING NON-MARRING OVERSHOE
Your tool is equipped with a protective plastic
overshoe that protects finer surfaces.
To attach, hook overshoe over front of metal
footplate and snap into place at rear of
footplate (Fig. 4).
FIG. 4
NON-MARRING
OVERSHOE
9G
Assembly
the guide roller To prevent damage to tool,
do not manually turn blade ejector lever
when inserting the blade
To change the saw blade, push the ejector
lever to the center stop; this releases and
ejects the saw blade (Fig. 3).
When changing the blade, tool should be
held so that the blade is safely ejected.
FIG. 2
BLADE
C
PLUNGER
BLADE EJECTOR
LEVER
To minimize splintering of the top surface of
the material being cut, place the anti-splinter
insert in the blade opening of the footplate, or
the non-marring overshoe (Fig. 5).
Note: This insert will only work with blades
that have ground sides such as T301CD,
TB1B, T101D, and T101DP.
FIG. 5
FOOTPLATE
-9-
PLUNGER
BLADE
ANTI-SPLINTER INSERT
ANTI-SPLINTER
INSERT
FIG. 3
BLADE
BLADE EJECTOR
LEVER