Table of Contents
Advertisement
obi
(12
Rear Panel
(10)
Name Plate
(11)
"ANT" Connector: Connect antenna
(12)
"TX" Connector: Connect the cable from the transceiver
(13)
Remote Control Terminal: Although HL-82V has an auto-
matic COX send/receive switch, HL-82V can also be con-
trolled remotely by the transceiver. (See item 8. of opera-
tion). Two lead wires should be connected to remote
output of the transceiver, which becomes "make" or
"short" when transmit.
(14)
Fuse Holder: 15A
(15)
DC Power Leads: Red for positive, black for negative.
* Setting and Operation
1.
Connect DC power leads to the DC power supply and/or the
battery, red lead to the positive (+) terminal and the black
one to the negative (-).
2.
Using a coaxial jumper cable (50 ohm type), connect "TX
(N)" of the rear panel to the Antenna connector of the
transceiver.
3.
Connect the antenna cable to the "ANT (OUT)" at the rear
panel.
4.
The impedance condition of the antenna used (or SWR)
must be checked to be 1.5 or less by using SWR meter.
5.
Operating the transceiver to "transmit", H L-82V is also
automatically operated to transmit.
Advertisement
Table of Contents
