LG RC9055 series Owner's Manual page 14

Operating Your Dryer
■
Please read before using your LG dryer for the first time
After removing the packaging, please carry out the following checks to ensure the LG
dryer is correctly installed and ready for use. (See installation instructions)
1. Check the dryer is well balanced by using a spirit level. If not, adjust the feet of the LG
dryer until the machine is balanced.
2. Check the water container, filter, control panel and drum to make sure everything is in
place.
3. Set the machine to dry for 5 minutes to warm up the drum.
4. Open the door between loads the first few times you use the machine to allow any
odours from the interior of the LG dryer to disperse.
NOTE
The final part of a tumble dryer cycle occurs without heat (cool down cycle) to
ensure that the items are left at a temperature to ensure that the items will not be
damaged.
1. Turn the power on.
First, press the ''Power'' button. The
indicator light above the button will
become illuminated indicating that the
machine is all set to run.
2. Open the door.
3. Check the filter and water container
are clean.
The filter is inside the door rim or in the
back of the door. It needs to be cleaned
before and after drying.
Open the door and check the filter is
clean. If not, please clean it referring to
page 21.
Also check if water container need to be
emptied for optimum drying results.
4. Place laundry into the drum after
sorting.
The clothes should be sorted by fabric
type and dryness level and all the strings
and belts of clothes should be well tied
and fixed before being put into the drum.
Push the laundry to the back to keep it
away from the door seal.
If not, the door seal and clothes may be
damaged.
Glass Door Opaque Door
Check the filter.
Turn the
power on.
Open the
Door.
13