Caliber RMD 574BT Manual
  1. Manuals
  2. Brands
  3. Caliber Manuals
  4. Car Receiver
  5. RMD 574BT
  6. Manual

Caliber RMD 574BT Manual

Hide thumbs Also See for RMD 574BT:

Advertisement

Table of Contents

Advertisement

Table of Contents
loading

Related Manuals for Caliber RMD 574BT

Summary of Contents for Caliber RMD 574BT

  • Page 2: Installation

    RMD 574BT Manual INSTALLATION Tools for Installation Use the 2 removal wrenches of the old unit to take out the old unit and place with this brand new car radio. The following tools and sup- plies may also be needed for the installation:...
  • Page 3 RMD 574BT Manual INSTALLATION WARNING! Disconnect negative battery terminal from battery before starting installation. Consult the vehicle’s owner’s manual for proper instructions. NOTE: Mark the polarity of the existing speaker wires before disconnecting battery. NOTE: Remove the two transport screws from the top of the unit before installing.

  • Page 4: Wiring Diagram

    RMD 574BT Manual WIRING DIAGRAM Microphone IN (3.5mm jack) > only for RMD574BT Parking brake (green) Reverse (purple/white) Steeringwheel control (3.5mm jack) Camera IN (yellow RCA) Video OUT (yellow RCA) Sub OUT (green RCA) Video IN (yellow RCA) Audio IN...
  • Page 5 RMD 574BT Manual WIRING DIAGRAM General Wiring Notes: Make sure You have a good chassis ground. Good ground connection will eliminate most electrical noise problems. A good chassis ground requires a tight connection to the .vehicle’s metal chassis. The area around the ground connection should be clean, bare metal without rust, paint, plastic, dust, or dirt for a good ground connection.

  • Page 6: Basic Operation

    RMD 574BT Manual Basic Operation 1. Turning the unit on/off Press the POWER button to turn the unit on. Press and hold the POWER button again to turn off. 2. Sliding out the monitor Press the TILT button so that the monitor will slide out automatically and the main GUI display will show up. Press the TILT button again so that the screen will go back in the chassis.
  • Page 7 RMD 574BT Manual Basic Operation Press SEL Button until the display shows “FAD”, then use the VOL +/- Button to adjust the balance between the front & rear speakers. F. Other Audio Settings You can adjust other audio settings like preset equalizer, loudness or subwoofer ON/OFF by tapping the “EQ” icon on the main menu, or on the control menu of other audio/video play modes.

  • Page 8: Radio Operation

    RMD 574BT Manual Radio Operation 1. Choose Radio Band Touch the BAND button onscreen to choose among the five radio bands - three FM Bands (FM1, FM2, and FM3) and two AM Bands (AM1, and AM2). Each of the five bands can store up to six preset stations, for a total of 30 preset memory stations.
  • Page 9 Bluetooth Operation (only for RMD574BT) PAIRING At BT mode, search bluetooth device by the phone and “RMD574BT Caliber” will appear in your phone. Input “0000” as password to establish connection. DIAL PAD Touch the dial pad to dial the number you would like to call. Touch the CALL (green) button to send the number.

  • Page 10: Usb/Sd Operation

    RMD 574BT Manual USB/SD Operation Plug the USB/SD card into the USB/SD port. The unit will play the contents automatically. 1. Advance/Go Back Advance to the next track or go back to the previous track by pressing the forward or rewind buttons on the front panel or touch screen.

  • Page 11: Other Operations

    RMD 574BT Manual Other Operations 1. AV Input The AV Input is a set of composite input on the rear of the unit. Press the Mode button to choose AUX. Connect any portable audio/ video device such as a DVD player or VCD player to unit. Use the volume control to adjust volume.

  • Page 12: Maintenance

    RMD 574BT Manual Maintenance Cleaning the Unit Do not use any liquids to clean this unit. Do not use petroleum distillates to clean this unit. Use a clean, dry cloth to clean this unit. Replacing the Fuse Make sure the amperage matches the specified value when replacing the fuse(s). If the fuse is bad, check the power connection and replace the fuse with a new one.

  • Page 13: Infrared Remote Control

    RMD 574BT Manual Infra Red Remote Control (Optional) 1. Power On/off 13. Time Clock Display/Statistical Disc 2. Mode Switch Button Information Display Button 3. Stop Playback 14. VOL + 4. Navigation Up 15. Play/Pause Function 5. Navigation Left 16. Sound Select Button 6.

  • Page 14: Simple Troubleshooting Guide

    RMD 574BT Manual Simple Troubleshooting Guide PROBLEM CAUSE / SOLUTION No Power Check whether the fuse is blown, replace with fuse of proper value if necessary. Unit stops responding or shows error Press the RESET button. in display Unable to receive radio stations Check whether the antenna is inserted or the antenna is properly connected;...

  • Page 15: Specifications

    RMD 574BT Manual Specifications GENERAL Operating Power............................12 Volts DC, Negative Ground Output Wiring..........................Designed for using four speakers only RCA line out..............................low-level outputs - 1000MV Output Impedance..........................Compatible 4 to 8 Ohm Speakers Fuses.........................................10 amp Dimensions............................178mm(W) x 170mm(D) x 58mm (H) Weight........................................2.0 Kg TFT/SYSTEM Resolution..................................800RGB(H) X 480(V)

This manual is also suitable for:

Rmd 574

Table of Contents