GBC ProCut 20P Installation And Operation Manual page 21

ProCut 20P – Installation and Operating Instructions
8. F
unctIon
There are eight functions which are as follows:
Function Name &
Rendered Drawing
Behind Blade Program
Behind blade program
01 00.00 02 03
00.00 00.00
05 00.00 06 00.00 07 00.00
In Front Blade Program
Front blade program
01 00.00 02 00.00 03 00.00
00.00 00.00 00.00
05 06 07
Unit of Measurement
Units
01 00.00 02 00.00 03 00.00
00.00 00.00 00.00
05 06 07
Buzzer Mode
Mute
01 00.00 02 00.00 03 00.00
00.00 00.00 00.00
05 06 07
Reblading Mode
Blade change mode
01 00.00 02 00.00 03 00.00
00.00 00.00 00.00
05 06 07
Reset
Reset
01 00.00 02 03
00.00 00.00
05 00.00 06 00.00 07 00.00
Count Value
000715
Total count
01 00.00 02 03
00.00 00.00
05 00.00 06 00.00 07 00.00
Clamping Force
Press
01 00.00 02 03
00.00 00.00
00.00 00.00 00.00
05 06 07
v
alues
Description
Behind Blade cutting
used in program setup.
00
04
00.00
08 00.00
In Front Blade cutting
used in program setup .
00
04 00.00
00.00
08
Measurements can be in
millimeters or inches .
inch
04 00.00
00.00
08
Ability to turn on/off the
audio warning for the
Safety Curtain.
04 00.00
00.00
08
Service mode used when
replacing the blade.
OFF
04 00.00
00.00
08
Service adjustment to
optimize performance.
OFF
04
00.00
08 00.00
Provides the total cuts
performed during the
lifetime of the machine .
04
00.00
08 00.00
Numeric value of
pressure applied to the
5 media by the Clamp.
04
00.00
00.00
08
When to Use
When doing large jobs with multiple cuts.
When doing large jobs with multiple cuts.
Use either option depending on personal preference.
You are turning off an audible warning for a safety
feature, use at your own discretion.
CALL YOUR LOCAL SERVICE TECH OR DEALER
FOR BLADE REMOVAL OR SHARPENING .
Used by the Service Technician.
After approximately 2,000 cuts the blade should be
sharpened.
When the paper is pulling out from under clamp during
cutting process or if too much pressure being applied
is leaving clamp marks on the media.
Page 8-1