Quick Installation - ViewSonic PF790 User Manual

Quick Installation

1 Connect video cable
Make sure both the monitor and computer
are powered OFF.
• Remove the lower rear cover and lift up the
upper rear cover.
• Connect the video cable to the computer,
then to the monitor.
Macintosh users: Models older than G3
require a Macintosh adapter. Attach the
adapter to the computer and plug the video
cable into the adapter.
To order a ViewSonic
send an email to vsparts@viewsonic.com or
contact ViewSonic. See "Customer Support"
on page 13.
2 Connect power cord and AC/DC
adapter
Connect the power cord and AC/DC adapter
from the monitor to a properly grounded AC
outlet.
3 Power-ON monitor and computer
Power-ON the monitor, then power-ON the
computer. This sequence (monitor before
computer) is very important.
NOTE: At this point Windows 98 users may
receive a message asking them to install the
PF790 INF file.
AC wall
outlet
4 ViewSonic PF790
®
Macintosh adapter,
4 Install Display Optimization files
(INF and ICM files)
(1) Insert the ViewSonic Wizard CD-ROM
into your computer's CD-ROM drive.
NOTE: If your computer does not have a
CD-ROM drive, See "Customer Support" on
page 13.
(2) Wait for the CD-ROM to auto-start.
NOTE: If the CD-ROM does not auto-start:
double-click on the CD-ROM icon in
Windows Explorer, then double-click on
install.exe.
(3) Follow the on-screen instructions.
5 Windows users: Set the Timing
Mode (resolution and refresh rate) Example:
1024 X 768 @ 75Hz.
For instructions on changing the resolution
and refresh rate, see the user guide for your
computer's graphics card.
Installation is complete.
Enjoy your new ViewSonic PF790
monitor.
To be best prepared for any future customer
service needs:
• Write the serial number (see back of the
monitor) in"For Your Records" on page 2 of
this guide.
• Register the warranty of your monitor on the
Internet at:
www.viewsonic.com/registration/
Power cord
Video cable